多项选择题All of the routers in the network are configured with the ip subnet-zero command. Which network addresses should be used for Link A and Network A (Choose two.)()。

A.Network A - 172.16.3.48/26
B.Network A - 172.16.3.128/25
C.Network A - 172.16.3.192/26
D.Link A - 172.16.3.0/30
E.Link A - 172.16.3.40/30
F.Link A - 172.16.3.112/30


您可能感兴趣的试卷

你可能感兴趣的试题

1.多项选择题

The switches shown in the diagram, Core and Core2, are both Catalyst 2950s. The addressing scheme for each company site is as follows:Router Ethernet port - 1st usable addressCore - 2nd usable addressCore2 - 3rd usable addressFor this network, which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet on the network? ()

A.Core2(config)# interface f0/0  Core2(config-if)# ip address 192.168.1.10 255.255.255.248
B.Core2(config)# interface vlan 1 Core2(config-if)# ip address 192.168.1.11 255.255.255.248
C.Core2(config)# line con 0 Core2(config-line)# password cisco
D.Core2(config)# line vty 0 4 Core2(config-line)# password cisco
E.Core2(config)# ip default-gateway 192.168.1.9
F.Core2(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.8


2.单项选择题Which type of EIGRP route entry describes a fesible successor?()

A.a primary route,stored in the routing table
B.a backup route,stored in the routingt able
C.a backup route,stored in the topology table
D.A primary route,stored in the topology table

3.单项选择题无类路由协议路由表表目为三维组,其中不包括()。

A.子网掩码
B.源网络地址
C.目的网络地址
D.下一跳地址

4.单项选择题VLAN tag在OSI参考模型的哪一层?()

A.应用层
B.表示层
C.会话层
D.传输层
E.网络层
F.链路层
G.物理层

7.多项选择题Which statements describe the routing protocol OSPF? ()

A.It supports VLSM.
B.It is used to route between autonomous systems.
C.It confines network instability to one area of the network.
D.It increases routing overhead on the network.
E.It allows extensive control of routing updates.
F.It is simpler to configure than RIP v2.

8.多项选择题Host 1 is trying to communicate with Host 2. The e0 interface on Router C is down. Which of the following are true (Choose two.)()。

A.Router C will use ICMP to inform Host 1 that Host 2 cannot be reached
B.Router C will use ICMP to inform Router B that Host 2 cannot be reached
C.Router C will use ICMP to inform Host 1, Router A, and Router B that Host 2 cannot be reached
D.Router C will send a Destination Unreachable message type
E.Router C will send a Router Selection message type
F.Router C will send a Source Quench message type

9.单项选择题Which IPV6 routing protocol uses multicast group FF02::8 to send updates?()

A.RIPng
B.OSPFv3
C.IS-IS for IPv6
D.static

10.多项选择题What information does a router running a link-state protocol use to build and maintain its topological database?()

A.hello packets
B.SAP messages sent by other routers
C.LSAs from other routers
D.beacons received on point-to-point links
E.routing tables received from other link-state routers
F.TTL packets from designated routers

最新试题

请参见图示。从主机X 发出的到主机Y 的tracert 命令已成功。下列哪一项正确地反映了追踪列表中显示的中间网络设备的顺序?()

题型:单项选择题

请参见图示。主机A 和B 无法互相通信。此问题的原因是什么?()

题型:单项选择题

何时必须使用clock rate 命令配置路由器串行接口?()

题型:单项选择题

请参见图示。一台路由器(其路由表如图所示)收到发往192.168.1.4的数据包。路由器将如何处理该数据包?()

题型:单项选择题

在路由器上使用Router#copy running-config startup-config 命令会产生什么效果?()

题型:单项选择题

OSI 哪一层可提供有序的数据重构服务?()

题型:单项选择题

请参见图示。某用户想要查看当前的配置。图中所示为ipconfig/all 命令的输出。从此输出可以得到哪三项结论?()

题型:多项选择题

请参见图示。主机B 尝试与主机C 建立TCP/IP 会话。在尝试期间,San Francisco 器由器的FastEthernet 接口fa0/1捕获到一个帧。捕获的帧中包含源IP 地址为10.10.1.2而目的IP 地址为10.31.1.20的数据包。捕获该帧时,它的目的MAC 地址是什么?()

题型:单项选择题

请参见图示。网络中的主机A 正在向主机B 发送数据段。有关所交换的数据段的流量控制如图所示。下列关于此通信的陈述,哪两项是正确的?()

题型:多项选择题

请参见图示。网络技术人员试图确定主机A 的正确IP 地址配置。以下哪一项是主机A 的有效配置?()

题型:单项选择题