A.length increases
B.cross-sectional area increases
C.temperature increases
D.percent of metallic purities increases
您可能感兴趣的试卷
你可能感兴趣的试题
A.the sum of the powers used in each load (resistor)
B.divided by the number of loads
C.always less than the power used in the smallest load
D.the sum of the powers used in each individual load never more than the power used in the largest load
A.series with a circuit
B.parallel with a circuit
C.series-parallel with a circuit
D.delta with the shunt
A.develop torque
B.generate high voltages
C.produce a magnetic field
D.generate high electrical resistance
A.connected load
B.prime mover speed
C.field excitation
D.generators rated voltage
A.doubled
B.quadrupled
C.unchanged
D.cut in half
A.voltage regulator
B.reverse power relay
C.reverse current relay
D.governor control switch
A.field excitation of both units is adjusted
B.governors of both units are adjusted
C.phase sequence is altered
D.kilowatt load is evenly divided
A.are less expensive
B.require less maintenance
C.can be started across the line
D.offer a more effective means of controlling speed
A.Alternators
B.Wave guides
C.Exciters
D.Amplidynes
A.quartered
B.unchanged
C.doubled
D.quadrupled
最新试题
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
If separating effect is not good, which measure should be taken ()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
() is not installed on the main switchboar.
The condensers located in various stages of a flash evaporator are cooled by()