A.port state control
B.flag state control
C.fire and boat drill
D.Safety inspection
您可能感兴趣的试卷
你可能感兴趣的试题
A.additional
B.permanent
C.temporary
D.long
A.detergent
B.de-oiling
C.defrosting
D.demulsifying
A.defrosting
B.de-oiling
C.demulsifying
D.dehumidifying
A.dispersant；detergent
B.detergent；dispersant
C.dispersant；dispersant
D.detergent；detergent
A.oxidation resistance
B.carbon-forming tendency
C.demulsibility
D.acidity
A.lower than
B.higher than
C.as same as
D.better than
A.the worse
B.the better
C.the smaller
D.the greater
A.absolute value
B.relative value
C.constant value
D.set value
A.TAN
B.TBN
C.SAN
D.SBN
A.due to
B.owing to
C.results from
D.results in
最新试题
Flame failure in an automatically fired auxiliary boiler can from a/an （）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
If separating effect is not good, which measure should be taken （）
Diesel engine air start system check valves are opened by （）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）