A.why
B.which
C.in which
D.on which
您可能感兴趣的试卷
你可能感兴趣的试题
A.until
B.not until
C.not before
D.not after
A.Heat is always transferred at a constant rate
B.Heat transfer rate increases as temperature difference increases
C.The rate of heat transfer is not affected by temperature difference
D.The high temperature region is known as a heat sink
Which of the following operations must be entered on the Oil Record Book Part Ⅰ? ()
Ⅰ.Routine discharge at sea of bilge water containing oil from the machinery spaces
Ⅱ.Bunkering of fuel oil
A.Ⅰ only
B.Ⅱ only
C.both Ⅰ and Ⅱ
D.neither Ⅰ nor Ⅱ
A.ammeter
B.voltmeter
C.wattmeter
D.frequency meter
A.wrap the arm in a tight bandage
B.soak the arm in hot salt water
C.cover the burn with petroleum jelly
D.put the burn in cold water
A.SOLAS 74
B.MARPOL 73/78
C.STCW 78/95
D.ISM Code
A.the owner of the ship
B.the manager who assumes the responsibility for operation of the ship
C.the bareboat charterer
D.All of the above
A.physical state
B.temperature
C.atmospheric pressure
D.sensible pressure
A.it is difficult for them to finish the job in time
B.difficult for them to finish the job in time
C.they have much difficulty to finish the job in time
D.that difficult for them to finish the job in time
A.the third engineer
B.the PSCO
C.the surveyor
D.the chief engineer
最新试题
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
Under MARPOL Code the ship to which it applies has to carry ()
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the()
()are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
The condensers located in various stages of a flash evaporator are cooled by()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
If separating effect is not good, which measure should be taken ()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()