A.vaporize, with the un-flashed water remaining at the temperature at which it entered the flash chamber
B.vaporize, with the un-flashed eater equalizing to the saturation conditions existing in the f lash chamber
C.vaporize, with the remaining water a t a temperature greater than it entered the flash chamber
D.boil, allowing steam bubbles to rise through the brine at the bottom of the flash chamber
您可能感兴趣的试卷
你可能感兴趣的试题
A.combined as part of the salt water feed heater
B.the open area above the brine levels in the first and second stages
C.combined as part of the distillate cooler
D.another term used to describe the vapor feed heater
A.distilling condenser
B.salt water feed heater
C.distillate cooler
D.flash chamber
A.higher than the first stage feed-water temperature and absolute shell pressure
B.lower than the first stage feed-water temperature and absolute shell pressure
C.the same as the first stage feed-water temperature and absolute shell pressure
D.not related to the feed-water temperature and absolute shell pressure
A.lowering brine discharge density
B.decreasing the absolute pressure of each stage
C.increasing the saltwater feed heater temperature
D.increasing the pressure at the spray pipe
A.Bedplate
B.Block
C.Base
D.Sump
A.clearance between the top of the valve stem and the rocker arm
B.compression of the valve springs
C.clearance between the valve seat inserts and the head
D.out of roundness of the fuel injection cams
A.low lube oil temperature
B.low lube oil pressure
C.high exhaust temperature
D.high cooling water pressure
A.Dirty lube oil filter
B.Too much piston ring wear
C.High lube oil viscosity
D.Low lube oil temperature
A.The oil oxidizes and forms carbon deposits
B.The viscosity increases
C.Engine oil consumption decreases
D.Lubricating qualities of the oil are enhanced
A.pitting
B.sludge
C.hard varnish
D.all of the above
最新试题
（） is not installed on the main switchboar.
The additional mark （）in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.
Diesel engine air start system check valves are opened by （）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
If separating effect is not good, which measure should be taken （）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
The main purpose of port State control is not to（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Under MARPOL Code the ship to which it applies has to carry （）