A.the session layer
B.the protocol layer
C.the data link layer
D.the access layer
E.the network layer
F.the application layer

A.It supports VLSM.
B.It is used to route between autonomous systems.
C.It confines network instability to one area of the network.
D.It increases routing overhead on the network.
E.It allows extensive control of routing updates.
F.It is simpler to configure than RIP v2.

A.Router C will use ICMP to inform Host 1 that Host 2 cannot be reached
B.Router C will use ICMP to inform Router B that Host 2 cannot be reached
C.Router C will use ICMP to inform Host 1, Router A, and Router B that Host 2 cannot be reached
D.Router C will send a Destination Unreachable message type
E.Router C will send a Router Selection message type
F.Router C will send a Source Quench message type

A.RIPng
B.OSPFv3
C.IS-IS for IPv6
D.static

A.hello packets
B.SAP messages sent by other routers
C.LSAs from other routers
D.beacons received on point-to-point links
E.routing tables received from other link-state routers
F.TTL packets from designated routers

A.Each OSPF area requires a loopback interface to be configured.
B.Areas may be assigned any number from 0 to 65535.
C.Area 0 is called the backbone area.
D.Hierarchical OSPF networks do not require multiple areas.
E.Multiple OSPF areas must connect to area 0.
F.Single area OSPF networks must be configured in area 1.

A.transparent
B.auto
C.on
D.desirable
E.blocking
F.forwarding

A.amount of RAM
B.bridge priority
C.IOS version
D.IP address
E.MAC address
F.speed of the links

A.dataintegrity
B.encryption
C.keyexchange
D.authentication