单项选择题Which protocol is an open standard protocol frame work that is commonly used in VPNs,to provid secureend-to-end communication?()

A.L2TP
B.IPsec
C.PPTP
D.RSA


您可能感兴趣的试卷

你可能感兴趣的试题

3.单项选择题

根据下图中展示的show  running-config命令的结果。网络管理员该如何做才能允许工作站连接到FastEthernet0/0接口去获得一个IP地址?()

A.在接口FastE thernet0/0应用access-group14
B.在access-list14中添加access-list 14 permit any any
C.配置FastE therent0/0接口的IP地址为10.90.201.1
D.为接口FastE thernet0/0添加一个接口描述

4.多项选择题What three pieces of information can be used in an extended access list to filter traffic (Choose three.)()。

A.protocol
B.VLAN number
C.TCP or UDP port numbers
D.source switch port number
E.source IP address and destination IP address
F.source MAC address and destination MAC address

5.单项选择题Acknowldgement, Sequencing, and Flow control are characteristics of which OSI layer?()

A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 5
E.Layer 6
F.Layer 7

6.单项选择题The administrator is unable to establish connectivity between two Cisco routers. Upon reviewing the command output of both routers, what is the most likely caust of the problem?()

A.Authentication needs to be changed to PAP for both routers.
B.Serial IP addresses of routers are not on the same subnet.
C.Username/password is incorrectly configured.
D.Router names are incorrectly configured.

7.多项选择题

Exhibit: Which of the following are true regarding the command output shown in the display (Choose two.)()。

A.There are at least two routers participating in the RIP process.
B.A ping to 192.168.168.2 will be successful.
C.A ping to 10.0.15.2 will be successful.
D.RtrA has three interfaces participating in the RIP process.

9.单项选择题哪个路由协议默认用带宽和延迟作为metrics值?()

A.RIP
B.BGP
C.OSPF
D.EIGRP

10.多项选择题Which can be done to secure the virtual terminal interfaces on a router?()

A.Administratively shut down the interfaces.
B.Physically secure the interfaces.
C.Configure a virtual terminal password and login process.
D.Enter an access list and apply it to the terminal interfaces using the access-class command.
E.Create an access list and apply it to the terminal interfaces using the access-groupc ommand.

最新试题

请参见图示。从主机X 发出的到主机Y 的tracert 命令已成功。下列哪一项正确地反映了追踪列表中显示的中间网络设备的顺序?()

题型:单项选择题

OSI 模型的哪两项功能在第2层实现?()

题型:多项选择题

请参见图示。一台主机正使用NAT 连接到Internet。下列哪三项IP 地址可实现此连接?()

题型:多项选择题

请参见图示。在网络中,PC1向PC2发送了一条消息。PC2收到的帧如图所示。该帧中的哪一信息确定了正确的目的应用程序?()

题型:单项选择题

请参见图示。网络技术人员使用图中所示的连接将主机A 连接到路由器以创建初始配置。下列有关此连接的陈述中哪一项正确?()

题型:单项选择题

何时必须使用clock rate 命令配置路由器串行接口?()

题型:单项选择题

请参见图示。网络中的所有设备均使用默认配置。此拓扑中存在多少个广播域?()

题型:单项选择题

路由器使用哪一项信息来确定源主机和目的主机之间的路径?()

题型:单项选择题

请参见图示。公司路由器由于故障被更换。更换路由器之后,Education 办公室内的主机C 和D 能够相互ping 通,但是无法访问Accounts 办公室内的主机。此问题的原因可能是什么?()

题型:单项选择题

请参见图示。主机X 和主机Y 与本地网络的通信受到限制。此问题的原因是什么?()

题型:单项选择题