Refer to the exhibit.Which statement describes DLCI 17?()
A.DLCI 17 describes the ISDN circuit between R2 and R3.
B.DLCI17 describes a PVC on R2.It cannot be used on R3 or R1.
C.DLCI17 is the Layer 2 address used by R2 to describe a PVC to R3.
D.DLCI17 describes the dial-up circuit from R2 and R3 to the service provider.
您可能感兴趣的试卷
你可能感兴趣的试题
A.show session
B.show cdp neighbors
C.show users
D.show queue
A.RIP requires less time to converge
B.RIP uses less bandwidth
C.RIP is less complex to configure
D.RIP demands fewer router resources
E.RIP has a more accurate metric
A.transport type all
B.transport output all
C.transport preferred all
D.transport input all
A.131.1.123.30
B.131.1.123.31
C.131.1.123.32
D.131.1.123.33
A.The switch will not forward unicast frames.
B.The switch will forward the frame to a specific port.
C.The switch will return a copy of the frame out the source port.
D.The switch will remove the destination MAC from the switch table.
E.The switch will forward the frame to all ports except the port on which it was received.
A.802.1d
B.VTP
C.802.1q
D.STP
E.SAP
A.an OSPF update for network 192.168.0.0/16
B.a static router to network 192.168.10.0/24
C.a static router to network 192.168.10.0/24 with a local serial interface configured as the next hop
D.a RIP update for network 192.168.10.0/24
E.a directly connected interface with an address of 192.168.10.254/24
F.a default route with a next hop address of 192.168.10.1
A.VTP
B.802.1q
C.IGP
D.ISL
E.802.3u
A.The command establishes a static route.
B.The command invokes a dynamic routing protocol for 192.168.12.0.
C.Traffic for network 192.168.12.0 is forwarded to 172.16.12.1.
D.Traffic for all networks is forwarded to 172.16.12.1.
E.This route is automatically propagated throughout the entire network.
F.Trafficfor network 172.16.12.0 is forwarded to the 192.168.12.0 network.
A.session
B.network
C.physical
D.data link
E.transport
最新试题
请参见图示。RouterB 已经过正确配置。RouterA 的以太网接口Fa0/0已使用如图所示的命令进行配置。但是,从RouterA 的Fa0/0接口无法成功ping 通RouterB 的Fa0/0接口。应在RouterA 上采取什么措施来解决此问题?()
OSI 模型的哪两项功能在第2层实现?()
请参见图示。公司路由器由于故障被更换。更换路由器之后,Education 办公室内的主机C 和D 能够相互ping 通,但是无法访问Accounts 办公室内的主机。此问题的原因可能是什么?()
在路由器上使用Router#copy running-config startup-config 命令会产生什么效果?()
请参见图示。一台路由器(其路由表如图所示)收到发往192.168.1.4的数据包。路由器将如何处理该数据包?()
PC 无法连接到任何远程网站,无法ping 通其默认网关,也无法ping 通本地网段中工作正常的打印机。以下哪项操作可以确认此PC 上的TCP/IP 协议栈是否工作正常?()
请参见图示。电缆1和电缆2分别按照特定的物理层要求接线。哪三个网段使用电缆2?()
请参见图示。主机A 和B 无法互相通信。此问题的原因是什么?()
请参见图示。网络技术人员使用图中所示的连接将主机A 连接到路由器以创建初始配置。下列有关此连接的陈述中哪一项正确?()
请参见图示。主机B 尝试与主机C 建立TCP/IP 会话。在尝试期间,San Francisco 器由器的FastEthernet 接口fa0/1捕获到一个帧。捕获的帧中包含源IP 地址为10.10.1.2而目的IP 地址为10.31.1.20的数据包。捕获该帧时,它的目的MAC 地址是什么?()