A.10Mbps
B.11Mbps
C.54Mbps
D.100Mbps
您可能感兴趣的试卷
你可能感兴趣的试题
A.The port is experiencing errors.
B.The port is administratively disabled.
C.The port is blocked by spanning tree.
D.The port has an active link with normal traffic activity.
A.127.0.0.1
B.172.16.0.1
C.192.168.0.5
D.223.0.0.1
E.224.0.0.5
F.254.255.255.255
In order to allow the establishment of a Telnet session with a router, which set of commands must be configured?()
A.A
B.B
C.C
D.D
E.E
F.F
A.the session layer
B.the protocol layer
C.the data link layer
D.the access layer
E.the network layer
F.the application layer
A.amount of RAM
B.bridge priority
C.IOS version
D.IP address
E.MAC address
F.speed of the links
A.255.255.255.0
B.255.255.255.240
C.255.255.255.248
D.255.255.255.252
E.255.255.255.254
A.RIP
B.BGP
C.OSPF
D.EIGRP
A.hub
B.router
C.switch
D.STP
E.subinterfaces
F.VLAN
A.This is a 10 Mb/s switch port.
B.This is a 100 Mb/s switch port.
C.This is an Ethernet port operating at half duplex.
D.This is an Ethernet port operating at full duplex.
E.This is a port on a network interface card in a PC
A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR, FHSS, and DSSS
最新试题
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
Which IPsec security protocol should be used when confidentiality is required?()
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()
Which pairing reflects a correct protocol-and-metric relationship?()
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()
Which command is used to display the collection of OSPF link states?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()