A.A more efficient use of bandwidth can be achieved allowing many physical groups to use the same network infrastructure
B.Broadcast storms can be mitigated by decreasing the number of broadcast domains,thus increasing their size.
C.A higher level of network security can be reached by separating sensitive data traffic from other network traffic.
D.Port-based vlans increase switch-port use efficient,thanks to 802.1Q trunks
E.A more efficient use of bandwidth can be achieved allowing many logical networks to use the same network infrastructure.
F.Broadcast storms can be mitigated by increasing the number of broadcast domains,thus reducing their size.
G.VLANs make it easier for IT staff to configure new logical groups,because the vlans all belong to the same broadcast domain.

A.More collision domains will be created.
B.IP address utilization will be more efficient.
C.More bandwidth will be required than was needed previously.
D.An additional broadcast domain will be created.

A.32768: 11-22-33-44-55-66
B.32768: 22-33-44-55-66-77
C.32769: 11-22-33-44-55-65
D.32769: 22-33-44-55-66-78

A.802.1d
B.VTP
C.802.1q
D.STP
E.SAP

A.It designates VLAN 999 for untagged traffic.
B.It blocks VLAN 999 traffic from passing on the trunk.
C.It creates a VLAN 999 interface.
D.It designates VLAN 999 as the default for all unkown tagged traffic.

A.switch-1 will drop the data because it dose not have an entry for that MAC address
B.switch-1 will flood the data out all of its port from which the data originated
C.switch-1 will forward the data to its default gateway
D.tch-1 will send an ARP request out all its ports except the port from which the data originated

A.lowest port MAC address
B.port priority number and MAC address.
C.VTP revision number
D.highest port priority number.
E.path cost

A.Switch A ,because it has the lowest MAC address
B.Switch C,because it has the lowest priority
C.Switch B,because it has the highest MAC address
D.Switch C,because it is the most centrally located switch
E.Switch A,because it is the most centrally located switch
F.Switch D,because it has the highest priority

A.to uniquely identify devices at Layer 2
B.to allow communication with devices on a different network
C.to differentiate a Layer 2 frame from a Layer 3 packet
D.to establish a priority system to determine which device gets to transmit first
E.to allow communication between different devices on the same network
F.to allow detection of a remote device when its physical address is unknown

A.the IP address of Switch 1
B.the MAC address of Switch 1
C.the IP address of Host C
D.the MAC address of Host C
E.the IP address of the router's E0 interface
F.the MAC address of the router's E0 interface