A.it is a layer 2 messaging protocol which maintains vlan configurations across network.
B.it includes an 8-bit field which specifies the priority of a frame.
C.it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D.it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E.it is a trunking protocol capable of carring untagged frames.
您可能感兴趣的试卷
你可能感兴趣的试题
Based on the network shown in the graphic which option contains the potential networking problem and protocol or setting that can to prevent the problem?（）
A.Routing loops, hold down timers
B.Switching loops, split horizon
C.Routing loops, split horizon
D.Switching loops, VTP
E.Routing loops, STP
F.Switching loops, STP
A.ping address
B.tracert address
C.traceroute address
D.arp address
A.added security
B.dedicated bandwidth
C.provides segmentation
D.allows switches to route traffic between subinterfaces
E.contains collisions
Refer to the exhibit. Which statement is true?（）
A.The Fa0/11 role confirms that SwitchA is the root bridge for VLAN 20.
B.VLAN 20 is running the Per VLAN Spanning Tree Protocol.
C.The MAC address of the root bridge is 0017.596d.1580.
D.SwitchA is not the root bridge, because not all of the interface roles are designated.
A.source MAC address
B.source IP address
C.source switch port
D.destination IP address
E.destination port address
F.destination MAC address
A.data link
B.network
C.physical
D.transport
A.RSTP significantly reduces topology reconverging time after a link failure.
B.RSTP expends the STP port roles by adding the alternate and backup roles.
C.RSTP port satates are blocking,discarding,learing,or forwarding.
D.RSTP also uses the STP proprsal-agreement sequence.
E.RSTP use the same timer-baseed process as STP on point-to-point links.
F.RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.
Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）
A.trunk mode mismatches
B.vlans that do not correspond to a unique IP subnet
C.native vlan mismatches
D.allowing only vlan 2 on the destination.
Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links are operating at the same bandwidth? （）
A.Switch A - Fa0/0
B.Switch A - Fa0/1
C.Switch B - Fa0/0
D.Switch B - Fa0/1
E.Switch C - Fa0/0
F.Switch C - Fa0/1
A.when a packet is received from an 802.1Q trunk,the vlan id can be determined from the source MAC address table.
B.unkown unicast frames are retransmitted only to the ports that belong to the same vlan
C.ports between switches should be configured in access mode so that vlans can span across the ports
D.broadcast and multicast frames are retransmitted to ports that are configured on different vlan.
最新试题
What are two enhancements that OSPFv3 supports over OSPFv2? （）
Which statement describes VRRP object tracking?（）
Syslog was configured with a level 3 trap. Which 3 types of logs would be generated？（）
What Netflow component can be applied to an interface to track IPv4 traffic?（）
What are three benefits of GLBP?（）
What are three factors a network administrator must consider before implementing Netflow in the network?（）
A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? （）
Which one of these is a valid HSRP Virtual Mac Address?（）
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow?（）
Which three statements about the features of SNMPv2 and SNMPv3 are true?（）