A.source IP address
B.destination IP address
C.per-packet load balance
D.destination MAC address
E.source MAC address
您可能感兴趣的试卷
你可能感兴趣的试题
Refer to the exhibit. What type of issue does this error log indicate if the IP address in the error log is located off of the Router A WAN?（）
A.HSRP standby configuration error
B.HSRP burned-in address error
C.HSRP secondary address configuration error
D.this is not an HSRP problem，but rather an STP error or router or switch configuration issue
Refer to the exhibit. Users from the Engineering VLAN complain that every time Business VLAN users have a network connectivity issue， the Engineering VLAN users usually have problems experiencing slow response or network connectivity problems. After troubleshooting， an unauthorized switch 2 was found. This unauthorized switch has been a regular problem， assuming the root bridge function under the spanning-tree domain and causing the Engineering VLAN to be unstable. Which three of these actions could be suggested to fix the problem？（）
A.Upgrade Spanning Tree Protocol to Rapid Spanning Tree Protocol.
B.Change Business VLAN PCs to switch 1 and switch 4.
C.Force the root bridge to be switch 2， instead.
D.Adjust spanning-tree timers （max-age and forward-delay）.
E.Shut down all unused ports.
F.Use MSTP to separate the Engineering VLAN from the Business VLAN to optimize spanning-tree convergence time within each VLAN.
A.prefixes received from any other BGP peer and prefixes locally originated via network statements or redistributed to BGP
B.all prefixes in its IP routing table
C.only prefixes received from EBGP peers and prefixes locally originated via network statements or redistributed
D.only prefixes received from EBGP peers and prefixes received from route reflectors
E.all prefixes in its routing table except the prefixes received from other EBGP peers
F.all prefixes in its routing table except the prefixes received from other IBGP peers
A.It is used only for directly connected subnets or aggregate routes.
B.It can only be used with LDP.
C.It is only used when two or more labels are stacked.
D.It enables the Edge LSR to request a label pop operation from its upstream neighbors.
E.It is requested through TDP using a special label value that is also called the implicit-null value.
F.It is requested through LDP using a special label value that is also called the implicit-null value.
A.nothing，BGP automatically load-balances the traffic between different autonomous systems on all available links
B.peer between the eBGP speaker’s loopbacks， configuring eBGP multihop as required， and use an IGP to load-share between the two equal-cost paths between the loopback addresses
C.configure a loopback as update source for both EBGP peers and have on each AS an IGP to introduce two equal-cost paths to reach the EBGP peer loopback address；it is also necessary to use the next-hop-self command
D.use the ebgp-load-balance command on the neighbor statement on both sides
E.configure a loopback as update source for both EBGP peers and have on each AS an IGP to introduce two equal-cost paths to reach the peer loopback address；it is also necessary to use the ebgp-multihop and next-hop-self commands
最新试题
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?（）
Which of the following describes the roles of devices in a WAN?（）
什么是NAT？
Local Preference？
Refer to the exhibit.How many broadcast domains exist in theexhibited topology？（）
QoS Mechanisms：问在部署QoS中要用的3个mechanisms是什么？
A default Frame Relay WAN is classified as what type of physical network?（）
What is the next state of initial in spanning-tree protocol？
hsrp speak状态是什么意思？
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）