单项选择题

Refer to the exhibit. Routers A and B are directly connected and running OSPF, but they are unable to form a neighbor relationship. What is the most likely cause?()

A. The routers are not on the same network.
B. The network statements do not match.
C. The process number does not match.
D. The MTU does not match.
E. The OSPF cost does not match.
F. There is a physical issue with the cable.


您可能感兴趣的试卷

你可能感兴趣的试题

1.单项选择题

Refer to the exhibit. Routers A and B are directly connected and running EIGRP, but they are unable to form a neighbor relationship. What is the most likely cause? ()

A. The network statements are misconfigured.
B. The IP address statements are misconfigured.
C. The autonomous system is misconfigured.
D. There is a physical issue with the cable.

3.单项选择题Which OSPF LSA type does an ASBR use to originate a default route into an area? ()

A. LSA 1
B. LSA 3
C. LSA 4
D. LSA 5
E. LSA 7

4.单项选择题Which one of these statements is true of OSPF type 5 LSAs? ()

A. They are used to summarize area routes to other areas.
B. They are used in not-so-stubby areas to propagate external routes.
C. They are used to notify areas of the ASBR.
D. They are flooded to all areas except stub areas (external route).

6.单项选择题During the IPv6 address resolution, a node sends a neighbor solicitation message in order to discover which of these? ()

A. The Layer 2 multicast address of the destination node
B. The solicited node multicast address of the destination node
C. The Layer 2 address of the destination node based on the destination IPv6 address
D. The IPv6 address of the destination node based on the destination Layer 2 address

8.多项选择题Which two of the following are considered valid router IDs for EIGRPv6?()

A.0.0.0.1
B.0.255.0.1
C.2001:DB8::1
D.2001:DB8:ABCD:FEEF::1

9.多项选择题Which two IPv6 address pairs can be assigned on a point-to-point link with a /125 mask?()

A.2001:DB8::1 and 2001:DB8::2
B.2001:DB8::9 and 2001:DB8::10
C.2001:DB8::10 and 2001:DB8::17
D.2001:DB8::1 and 2001:DB8::18

10.多项选择题Which three causes could prevent a host from getting an IPv6 address with stateless autoconfiguration?()

A.The autoconfig command is missing from the router interface.
B.IPv6 multicast routing is not enabled on the router interface.
C.IPv6 unicast routing is not enabled on the router interface.
D.The router interface is configured with a /63 mask.
E.The router interface is configured with a /65 mask.

最新试题

An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each,terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs,and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem?()

题型:单项选择题

Which types of prefixes will a router running BGP most likely advertise to an IBGP peer, assuming it is notconfigured as a route reflector?()

题型:单项选择题

Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain?()

题型:单项选择题

Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these?()

题型:单项选择题

Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0?()

题型:单项选择题

Based on the output provided in the exhibit, to which address or location will the router forward a packet sent to 192.168.32.1?()

题型:单项选择题

Which of the following is true about the MPLS header and its EXP field size?()

题型:单项选择题

In Layer 2 topologies, spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions?()

题型:多项选择题

What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link,but only allow eachindividual flow to use 1 MB/s?()

题型:单项选择题

Which of these statements about penultimate hop popping are true?()

题型:多项选择题