A. 128 bits and 256 bits
B. 128 bits and 384 bits
C. 1024 bits and 3072bits
D. 64 bits and 192 bits
E. 56 bits and 168 bits
F. 128 bytes and 384 bytes
您可能感兴趣的试卷
你可能感兴趣的试题
A. key mixing
B. AES-based encryption
C. anti-replay sequence counter
D. message integrity check
E. cyclic redundancy check
A. The ASA is configured for Active-Standby failover.
B. The ASA is configured for Active-Activefailover.
C. The ASA is configured for Active-Active failover and a state failover link has been configured.
D. The ASA is configured for Active-Standby failover and a state failover link has been configured.
E. The ASA is configured to use a serial cable as the failover link.
F. The ASA is configured for LAN-Based failover
A. Configure the SSH version that the router will use
B. Configure the host name of the router
C. Enable AAA Authentication
D. Configure the default IP domain name that the router will use
E. Enable SSH transport support onthe vty lines
A. To selectively apply drop actions to specific interfaces
B. To enable IOS to droptraffic for signatures configured with the Drop action
C. To support load-balancing configurations in which traffic can arrive via multipleinterfaces
D. This is nota valid IOS command
A. The signatures available are built into the IOS code.
B. Toupdate signatures youneed to install a new IOS image
C. To activate new signatures you download a new Signature DefiitionFile （SDF） from Cisco’s web site
D. Loading and enabling selected IPS signatures is user configurable
E. Cisco IOS onlyprovides Intrusion Detection functionality
F. Cisco IOS-IPS requires a network module installed in your router running sensor software
A. The Pre-Block ACL is overwritten when a blockingaction is initiatied by the sensor
B. The blocking ACL entries generated by the sensor override the Pre-Block ACL entries
C. The Pre-Block ACL entries override the blocking ACL entries generated by the sensor
D. The Pre-Block ACL is replaced by the Post-Block ACL when a blocking actionis initiated bythe sensor
E. You can not configure a Pre-Block ACL when configuring IP Blockingon your sensor
A. 224.21.106.44
B. 224.25.106.44
C. 233.149.106.44
D. 236.25.106.44
E. 239.153.106.44
A. 00-00-1C-EF-00-00
B. 01-00-5E-00-00-05
C. 01-00-5E-EF-00-00
D. EF-FF-FF-00-00-05
E. EF-00-00-FF-FF-FF
F. FF-FF-FF-FF-FF-FF
A. 224.0.4.86
B. 224.4.86.0
C. 233.1.200.0
D. 239.2.213.0
E. 239.4.5.6
A. CDPmust be enabled on all switches in theVTP management domain.
B. All switches in the VTPdomain must run the same version of VTP.
C. When using secure mode VTP， only configure management domain passwords onVTP servers.
D. EnablingVTP pruning on a server willenable the feature for the entire management domain.
E. Use of theVTPmulti-domain feature should be restricted to migration and temporary implementation.
最新试题
When implementing internet standards you are required to follow RFC’s processes and procedures based onwhat RFC？（）
Which ones are the two type of ciphers？（）
Which access methods can CS-MARS use toget configuration information from an Adaptive SecurityAppliance （ASA）？ （）
What Cisco technology protects against Spanning-Tree Protocol manipulation？（）
What Cisco Switch feature best protects against CAM table overflow attacks？（）
Which is a benefit of implementing RFC 2827？（）
Cisco Clean Access ensures that computers connecting to your network have which of the following？（）
Which of the following is an example of a security technology that could be enabled by Netflow？（）
Which statements are true concerning NAT？ （）
What are the header sizes for point-to-point and multi-point GRE（also known asmGRE） with tunnel key？（）