Which of the followi...

多项选择题Which of the following is true about RADIUSV end or Specific Attribute？（）

A. The RADIUSVendor Specific Attribute type is decimal 26.
B. A radius server that does not understandthevendor-specific information sent by a clientmust reject the authentication request.
C. A vendor can freely choose theVendor-ID it wants to use when implementing Vendor Specific Attributes as long as the same Vendor-ID is used on all of its products.
D. Vendor Specific AttributeMUST include the Length field.
E. In Cisco’s Vendor Specific Attribute implementation， vendor-ID of 1 is commonly referred to as Cisco AV（Attribute Value） pairs.
F. Vendor Specific Attributes use a RADIUS attribute type between 127 and 255.

点击查看答案

您可能感兴趣的试卷

你可能感兴趣的试题

1.单项选择题Which one of the following is NOT a valid RADIUS packet type？（）

A. Access-reject
B. Access-response
C. Access-challenge
D. Access-reply
E. Access-accept

点击查看答案

2.单项选择题Which is a benefit of implementing RFC 2827？（）

A.Prevents DoS from legimate， non-hostile end systems
B.Prevents disruption of "special services"， such as Mobile IP
C.Defeats DoS Attacks which employ IPSource Address Spoofing
D.Restricts directed broadcasts at the ingress router
E.Allows DHCP or BOOTP packets to reach the relay agents asappropriate

点击查看答案

3.单项选择题When configuring a Cisco Adaptive Security Appliance in multiple context mode， which of the follow capabilities are supported？（）

A. Multicastis supported
B. Dynamic routing protocols are supported
C. VPN configurations are supported
D. Static routes are supported

点击查看答案

4.单项选择题When configuring system state conditions with the Cisco SecurityAgent， what is the resulting action when configuring more than one system state condition？（）

A.Any matching state condition will result with the state being triggered
B. Once a state condition ismet， the system ceases searching further conditions and will cause the state condition to trigger
C. All specified state conditions are used as part of the requirements tobe met to for the state to trigger
D. Once the state conditions are met， they become persistent and can only be removed using the Reset feature

点击查看答案

5.多项选择题The RiskRating for an IPS signatureis calculatedusing four primary components. Select the four components below. （）

A. SignatureFidelity Rating
B. Alert Severity Rating
C. Exploit Probability Rating
D. Target Value Rating
E. Attack Relevancy Rating

点击查看答案

6.多项选择题An IPS sensor with3 sniffing interfaces can be configuredas：（）

A. 3 promiscuous sensors
B. 3 inline sensors
C. 1 inline sensor， 1 promiscuous sensor
D. 2 inline sensors， 1 promiscuous sensors

点击查看答案

7.多项选择题Given the topology of a server （with IP 209.165.202.150） protected behind the inside interface of an ASA/PIX，and the Internet on the outside interface. Users on the Internet need to access the server at any time， but the firewall administrator does not want to NAT the address of the server - since itis currentlya public address. Which of the following commands can be used to accomplish this？（）

A. nat （inside） 0 209.165.202.150 255.255.255.255
B. access-list no-nat permit ip host209.165.202.150 anynat（inside） 0 access-list no-nat
C. static（inside，outside） 209.165.202.150 209.165.202.150 netmask 255.255.255.255
D. no nat-control
E. nat （inside） 1 209.165.202.150 255.255.255.255

点击查看答案

8.单项选择题What command can be used toglobally disable the requirement that a translation rulemust exist beforepackets can pass through the firewall？（）

A. nat 0
B. nonat-control
C. access-list
D. none of the above

点击查看答案

9.单项选择题Select thebest answer to this qestion. ASA/PIX Active/Active failover can be used toload-balance：（）

A. All traffic passing through theappliance
B. Traffic from internal networks on a per IP basis
C. Based on protocol only.
D. On a per-context basis only.

点击查看答案

10.单项选择题The number of packets （or flows） dropped because they do not conform to the ASA/PIX security policy can be viewed using what command？（）

A. show asp drop
B. show counters drop
C. show security-policy
D. show policy-map

点击查看答案