单项选择题What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway-Router?()

A. Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.
B. Gateway-Router is configured to only receive RIPv2 updates.
C. Gateway-router is configured to receive only RIPv1 updates.
D. Branch-Router1 is configured to only send RIPv1 updates


您可能感兴趣的试卷

你可能感兴趣的试题

1.单项选择题which address range efficiently summarizes the routing table of the addresses for router main?()

A. 172.16.0.0/18
B. 172.16.0.0/16
C. 172.16.0.0/20
D. 172.16.0.0/21

2.单项选择题assuming the default switch configuration which vlan range can be added modified and removed on a cisco switch?()

A. 2 through 1001
B. 1 through 1001
C. 1 through 1002
D. 2 through 1005

3.单项选择题which command is used to enable CHAP authentication whit PAP as the fallback method on a serial interface?()

A. (config-if)#authentication ppp chap fallback ppp
B. (config-if)#authentication ppp chap pap
C. (config-if)#ppp authentication chap pap
D. (config-if)#ppp authentication chap fallback ppp

4.单项选择题Which parameter or parameters are used to calculate OSPF cost in cisco routers?()

A. Bandwidth,Delay,and MTU
B. Bandwidth
C. Bandwidth and MTU
D. Bandwidth , MTU,Reliability,Delay,and Load

7.单项选择题Which PPP subprotocol negotiates authentication options?()

A. NCP
B. LCP
C. ISDN
D. DLCI
E. SLIP

9.单项选择题Assuming the default switch configuration,which approach should you use to configure the extended vlan range(1006 through 4094) on a cisco catalyst 3750 series switch?()

A. Configure the switch to be in VTP client mode.
B. Configure the switch to be in VTP domaint mode.
C. Configure the switch to be in VTP transparent mode.
D. Configure the switch to be in VTPv2.

10.单项选择题In which integration method is an IPV6 packet encapsulated within an IPV4 protocol?()

A. proxy.
B. dual-stack
C. tunneling
D. dot1q