单项选择题What does a Layer 2 switch do if it receives a frame with a destination MAC address that is not found in its MAC address table?()

A. The frame is dropped.
B. The frame is addressed with a broadcast MAC address and sent out all ports.
C. The frame is sent out all ports except the receiving port.
D. An ARP request is sent out all ports except the receiving port.
E. A destination unreachable message is sent back to the source address.
F. None of the above.


您可能感兴趣的试卷

你可能感兴趣的试题

1.多项选择题With regard to Ethernet media access methods, which of the following are true?()

A. A device waits for an electronic signal before transmitting.
B. A device listens and waits until the media is not busy before transmitting.
C. All devices on an Ethernet segment see data that passes on the network medium.
D. Only the sender and the receiver devices see data that passes on the network medium.
E. Ethernet networks allow you to configured devises with higher transmission priority.

2.单项选择题Which of the following are true of Ethernet technology?()

A. Hosts use a logical ring topology.
B. Hosts use a logical bus topology
C. Hosts must wait for an electronic signal to transfer data.
D. Hosts are directly connected to a wiring concentrator called a MSAU.

3.多项选择题Two stations on a LAN transmit at the same time, resulting in a collision. What happens when a collision occurs on the network?()

A. Each device on the Ethernet segment stops transmitting for a short time.
B. A jam signal informs all devices that a collision occurred.
C. When data transmission resumes, the devices that were involved in the collision have priority to transmit.
D. The devices that are involved in the collision stops transmitting for a short time.
E. The collision invokes a random back-off algorithm.

4.单项选择题Which of the addresses below is an example of a valid unicast address?()

A.172.31.128.255./18
B.255.255.255.255
C.192.168.24.59/30
D.224.0.0.5
E.All of the above

5.单项选择题Which one of the protocols below allows a router to respond to an ARP request destined to a remote host?()

A. Gateway DP
B. Reverse ARP
C. proxy ARP
D. Inverse ARP
E. indirect ARP

6.单项选择题Which of the following processes, is used to find the hardware address of a LAN device?()

A. Inverse-ARP
B. Reverse-ARP
C. Proxy ARP
D. ARP

7.多项选择题Which of the following are actual varieties of network crosstalk?()

A. near-end crosstalk(NEXT)
B. middle open-end crosstalk(MOEXT)
C. power sum near-end crosstalk(PSNEXT)
D. jitterry crosstalk(JEXT)
E. far end crosstalk(FEXT)

9.单项选择题What is the maximum data rate specified by the IEEE 802.11B standard for wireless LANS?()

A. 10 Mbps
B. 11 Mbps
C. 54 Mbps
D. 100 Mbps
E. none of the above

10.单项选择题Which IEEE standard is used to define Wi-Fi?()

A. IEEE 802.3
B. IEEE 802.5
C. IEEE 802.11h
D. IEEE 802.11c
E. IEEE 802.11