A.Yes,by modifying the LWAPP frame header DSCP value in transit.
B.Yes,by modifying the LWAPP frame header 802.1p value in transit.
C.No,the WMM queue classification parameter is transported inside the LWAPP tunnel.
D.No,the WMM queue classification parameter is determined at the AP based on the original client IP header DSCP value.
您可能感兴趣的试卷
你可能感兴趣的试题
A.Voice traffic should be marked to DSCP EF per the QoS baseline and RFC3246.
B.Voice traffic loss should be no more than 3%.
C.One-way latency (mouth-to-ear) should be less than 150 msec.
D.Average one way jitter should be targeted to less than 30 msec.
E.21-320 Kbps of guaranteed priority bandwidth is required per call depending on sample rate,codec,and layer 2 overhead.
A.audit VoWLAN cell edge coverage
B.verify RFID tag coverage by four access points at -75 dBm
C.audit microwave oven interference
D.audit 802.11a channel 36 utilization
E.create test scripts for 802.11n bonded channel throughput tests
A.802.11e
B.802.11k
C.802.11i
D.802.11h
A.passed by the AP to its connected switch and then forwarded directly to the connected router,which creates an MGID table entry
B.passed by the AP to the WLAN controller and then forwarded to the source PIM-enabled router,which creates an MGID table entry
C.passed by the AP to the WLAN controller, which creates an MGID table entry before forwarding to the directly connected PIM-enabled router
D.passed by the AP to its connected switch and then forwarded to the rendezvous point router,which creates an MGID table entry
A.to determine if there are more clients that are using the multicast stream
B.to limit the time that a client has to request an IGMP join to the controller multicast group
C.to determine if the multicast router is still alive and responding to multicast clients
D.to remove clients from the multicast group if the multicast traffic exceeds the allotted bandwidth allowed for multicast clients
A.TSPEC IE
B.TSRS IE
C.WMM IE
D.TSM IE
A.Wireless client WMM UP classification is translated to a wired DSCP priority.
B.Wireless client 802.11p classification is translated to a wired DSCP priority.
C.Wireless client WMM UP classification is translated to a wired 802.1p CoS priority.
D.Wireless client 802.11p classification is translated to a wired 802.1p CoS priority.
A.Packet loss is less than one percent.
B.Signal strength at cell edge is approximately -67 dBm.
C.End-to-end delay is less than 200 ms.
D.Cell overlap between APs is 50 percent.
A.the codec used by the calling phone
B.approximate length of the call in minutes
C.MOS values throughout the duration of the call
D.802.11e access category overruns
E.co-channel interference percentage during the call
A.Client issues an IGMP join after association with AP2, allowing AP2 to request a multicast stream from Cisco WLC after AP1 issues an IGMP query.
B.Client issues an IGMP join after association with AP2, allowing AP2 to request a multicast stream from Cisco WLC independent of AP1 multicast member status.
C.Client resumes multicast after association with AP2, because multicast information is sent in mobility exchanges and AP2 is already a member of the multicast group, provided that another client has already joined that multicast.
D.Client resumes multicast after association with AP2, because multicast information is sent in mobility exchanges and AP2 is already a member of the multicast group, regardless if any other clients have already joined that multicast.
最新试题
Which statement is correct for both the LWAPP and CAPWAP AP upstream 802.1Q tagged wired QoS priority for a WMM-associated client frame that is H-REAP locally switched running v5.2?()
What is the minimum configuration you must do in order to enable multicast support on the CiscoWireless LAN Controller v5.2?()
Which two statements correctly describe a Cisco WLC configuration of Wireless > QoS > Profiles >Wired_QoS_Profiles for an implementation of DSCP or CoS deployment?()
What call performance statistics are reported on the Cisco Wireless IP Phone 7921 user interface?()
Which configuration should be done in order to improve the performance of the Cisco Unified Wireless IP Phone 7921G in a WLAN infrastructure?()
For which WMM queue is U-APSD most beneficial?()
Which three actions are required to access the network statistics on a remote Cisco Unified Wireless IP Phone 7921G via a web browser?()
For which quality of service parameter should the WLAN for VoWLAN clients be configured?()
Which three solutions does AirMagnet VoFi Pro Analyzer integrate?()
Which wireless LAN statistics are reported from the Cisco Unified Wireless IP Phone 7921G via a directly connected web browser?()