A. Configure TCP header compression on interface
B. Configure MPL on the Frame Relay interfaces
C. Configure FRF 12 fragmentation on the Frame Relay interfaces
D. Fragmentation is not supported with service internetworking
您可能感兴趣的试卷
你可能感兴趣的试题
The following exhibit displays the NetFlow statistics for a CIS router, which will be helpful for a network administrator to collect IP traffic information.
Which two numbers separately refer to the percentage of packets sized between 32 and 64 bytes and the number of flows in progress?()
A. 24.9%, 980
B. 6.94%, 980
C. 69.4%, 35
D. cannot be determined from this output
E. 69.4%, 4061
You work as a network administrator in your company. Communication inside the company is ensured by network environments, such as GET VPN, Dynamic Multipoint VPN and Ethernet.
Which PIN architecture is applicable in those environments?()
A.Campus
B.Teleworker
C.Branch
D.Data center
A. Branch
B. Campus
C. Teleworker
D. Data center
Refer to the exhibit. Which two of these accurately describe this router's supervisor redundancy status? ()(Choose two.)
A. both supervisors are active
B. SSO redundancy is being used
C. the second supervisor is unavailable
D. the primary supervisor is unavailable
E. the primary supervisor was reloaded nine seconds ago
Refer to the exhibit. What is the HSRP state and priority of this interface after HSRP reaches its steady state?()
A. Active, Priority 151
B. Active, Priority 201
C. Active, Priority 251
D. Standby, Priority 151
E. Standby, Priority 201
F. Standby, Priority 251
HSRP. Known as Hot Stanclby Router Protocol, is a Cisco proprietarv redundancy protocol . As an experienced network administrator, you are required to configure HSRP on a XYZ network.
Which TWO of the following wii be available and shared between the routers configured with HSRP? ()(Choose two.)
A. a shared single interface
B. the ability to track serial interfaces
C. UDP-based hello packets
D. the impact of flapping links if timers are too low
A. It is achieved by using more than one HSRP group.
B. It is done in regards to either round robin or weight basis.
C. It is used to offload the active router in a certain HSRP group.
D. The return traffic is influenced by HSRP load sharing configuration.
E. Single group HSRP is used to achieve more efficient link utilization.
A.0000.5E00.010a
B.0000.0c07.ac0a
C.0000.0c07.0110
D.000.0cac.070a
A. Proxy ARP
B. IRDP
C. Dynamic Routing Protocol
D. VRRP
A.Both Gateway Load Balancing Protocoland Hot Stand by Router Protocol
B.Gateway Load Balancing Protocol
C.Virtual Router Redundancy Protocol
D.Hot Stand by Router Protocol
最新试题
Which description is making sense on the basis of the given information?()
Which three of these items are IPv6 transition mechanisms? ()(Choose three.)
What is the purpose of using VPN hardware acceleration equipment?()
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?()
Which command displays only those entries in a BGP table with specific AS_PATH attributes?()
As an experienced technician, you are responsible for Technical Support in your company. One of the trainees is asking you which Cisco VPN Acceleration Module for Cisco 7200 Series routers and the Cisco 7301 provides high-performance encryption/compression and supports the latest encryption standard.Which of the following will answer his question?()
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?()
You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?()
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?()
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?()