JN0-101章节练习(2020.05.10)

A. Create a static route on Router 1 to 192.17.28.1 with a next hop of 10.10.10.2
B. Create a static route on Router 1 to 172.17.28.1 with a next hop of 10.10.10.1
C. Create a static route on Router 2 to 172.17.25.1 with a next hop of 10.10.10.1
D. Create a static route on Router 2 to 172.17.25.1 with a next hop of 10.10.10.2

A. show route
B. show route inet 0 direct
C. show ip route direct
D. show ip route protocol direct

A. "Configure"
B. "Troubleshoot"
C. "Monitor"
D. "Maintain"

A. Create a static route on Router 1 to 172.17.28 1 with a next hop of 10.10.10.2
B. Create a static route on Router 1 to 172.17.28 1 with a next hop of 10.10.10.1
C. Create a static route on Router 2 to 172.17.25.1 with a next hop of 10.10.10.1
D. Create a static route on Router 1 to 172.17.25.1 with a next hop of 10.10.10.2

A. It is the address used by default as the local address for broadcast and multicast packets sourced locally and sent out of the interface
B. You use the primary address when you have multiple IP addresses belonging to the same subnet on the same interface
C. It can be useful for selecting the local address used for packets sent out of unnumbered interfaces when multiple non-127 addresses are configured on the loopback interface
D. By default, the primary address on an interface is selected as the numerically highest local address configured on the interface

A. /var/home/user
B. /var/config/save0/
C. /var/tmp
D. /config

A."Configure"
B."Troubleshoot"
C."Monitor"
D."Maintain"

A. Each process has its own protected memory space
B. Each process is started manually by the user at boot
C. Aall processes are dependent on each other
D. Multiple processes allow each routing protocol to be independent

A. as an outbound filter on interface fxp0
B. as an outbound filter on interface lo0
C. as an inbound filter on interface fxp0
D. as an inbound filter on interface lo0

A. OSPF SPF daemon (ospfd)
B. SNMP daemon (snmpd)
C. BGP daemon (bgpd)
D. Routing protocols daemon (rdp)