A.excessive pump speed
B.excessive suction head
C.worn wearing rings
D.gross pump misalignment
您可能感兴趣的试卷
你可能感兴趣的试题
A.Distillation is the process of boiling seawater to produce vapor which is condensed into fresh water
B.Evaporation is the second part of the distillation process where brine is removed
C.Brine is the result of condensed sea water vapor
D.Distillate is the product resulting from the evaporation of fresh water vapor
A.absolute humidity
B.specific humidity
C.effective humidity
D.relative humidity
A.drain water from the air receiver
B.drain water from the cylinders
C.delay the compression process until the motor is up to speed
D.check pump alignment
A.face shield
B.a respirator
C.rubber gloves
D.an all purpose gas mask
A.lantern rings
B.bearings
C.easing volutes
D.wearing rings
A.packing gland
B.mechanical seals
C.lantern rings
D.wearing rings
A.through a detachable hose connection
B.after passing through an activated charcoal filter
C.after chemical analysis shows it is fit for consumption
D.through a solenoid operated three-way valve
A.worn gland sealing shaft
B.worn wearing rings
C.a bent shaft
D.reversed pump coupling
A.A power end and fluid end
B.A propeller and educator
C.A volute and impeller
D.A turbine and piston
A.water seal pipe is plugged
B.pump is not primed
C.seal ring is improperly located
D.impeller is flooded
最新试题
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
The general purpose of a heat exchanger is to ().
The major source of chemical contaminants in hydraulic fluid is ().
Which of the listed pumps is NOT a positive displacement pump?()
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?()
The output volume of a positive fixed displacement pump can be changed only by ().
An excessive charge of refrigerant in an air-cooled refrigeration system can cause ().
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should ().
Who is responsible for ensuring that someone is assigned to close the watertight doors in an emergency?()