A.restriction in refrigerant piping
B.air and non-condensable gases in the condenser
C.water in the refrigerant
D.flooding back of liquid refrigerant from the evaporator
您可能感兴趣的试卷
你可能感兴趣的试题
A.A shortage of liquid refrigerant
B.Excessive frost on the evaporator
C.Excessive condenser cooling water
D.Insufficient condenser cooling water flow
A.eliminate hot air from the condenser
B.maintain steady pressure in a system
C.heat, or cool one fluid by means of another fluid
D.reduce the engine room temperature in tropical climates
A.Cross
B.Parallel
C.Counter
D.Circular
A.remain constant along the tubes length
B.be greatest in a single pass counter flow heat exchanger
C.remain constant throughout the heat exchanger
D.vary from section to section through out the heat exchanger
A.a low load on the unit
B.a clogged pump suction strainer
C.a blockage in the line between the pump and hydraulic motor
D.the hydraulic motor turning too fast
A.cause of salt contamination
B.location of salt water contamination
C.chemical makeup of feed-water
D.level of alkalinity in condensate
A.refrigerant overcharge
B.overfeeding by the expansion valve
C.a restricted suction strainer
D.due to short cycling of the compressor
A.capacity will increase
B.capacity will decrease
C.suction pressure will increase
D.suction pressure will decrease
A.hydraulic
B.electric
C.steam
D.diesel
A.increase the amount of cooling water to the condenser
B.decrease the amount of cooling water to the condenser
C.add more refrigerant to the system
D.remove some refrigerant from the system
最新试题
A salinity indicator is used to determine the ().
The control mode in which the final control element is moved from one of two flexed positions to the other is known as ().
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will ().
A grease gun is generally used to lubricate a ().
Who is responsible for ensuring that someone is assigned to close the watertight doors in an emergency?()
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().
The general purpose of a heat exchanger is to ().
One cause of high head pressure occurring in a refrigeration system can be ().
A salinity indicator is used to determine the ().
Low compressor head pressure in a refrigeration system can be caused by().