A.capacity will increase
B.capacity will decrease
C.suction pressure will increase
D.suction pressure will decrease
您可能感兴趣的试卷
你可能感兴趣的试题
A.hydraulic
B.electric
C.steam
D.diesel
A.increase the amount of cooling water to the condenser
B.decrease the amount of cooling water to the condenser
C.add more refrigerant to the system
D.remove some refrigerant from the system
A.Heat is given off from a high temperature region known as a heat sink
B.Heat transfer rate is affected most by the size of the heat sink involved
C.Heat transfer rate is affected most by the temperature difference between the heat source and the heat sink
D.Heat transfer by radiation will occur only by mass motion of a fluid substance
A.Maritime Safety Administration
B.Master of the vessel
C.Chief Engineer
D.Chief Mate
A.size of the heat sink
B.temperature difference between the regions
C.size of the heat source
D.total heat of the system
A.the four-way control valve failing to shift
B.the bleeder valve sticking in the open position
C.cold hydraulic fluid
D.a clogged air vent falter on the oil reservoir
A.add fluid that is the same color as the fluid in the reservoir
B.add turbine oil because it is always a good substitute
C.add any oil that has the same viscosity as the hydraulic fluid
D.check the winch manufacturers instruction book
A.changing the angle of the tilting plate
B.changing the speed of the pump
C.moving the slide block and rotor
D.moving the shaft trunnion block
A.oil foaming in the compressor
B.higher than normal suction and discharge pressures with a higher box temperature
C.higher than normal discharge pressure with a normal box temperature
D.the compressor to run continuously
A.check hydraulic oil levels every hour
B.check the rams for overheating
C.check for excessive oil leakage from rams
D.drain water from telemotor cylinders each watch
最新试题
Low compressor head pressure in a refrigeration system can be caused by().
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will ().
Thermostatic expansion valves can be adjusted for ().
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is ().
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of ().
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
Which of the listed pumps is NOT a positive displacement pump?()
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its ().
A salinity indicator is used to determine the ().