A.trick wheel
B.accumulator
C.standby pump
D.telemotor
您可能感兴趣的试卷
你可能感兴趣的试题
A.Open the bilge pump for inspection
B.Remove each of the manifold valves
C.Remove only the manifold valve to the affected bilge-well
D.Attempt to pump out another bilge well to determine if the entire system is affected
A.too much refrigerant in the system
B.oil entrained in the refrigerant
C.less than a full charge of refrigerant in the system
D.ice crystals forming in the refrigerant
A.with both pumps on line at the same time
B.with one pump on standby
C.with the follow-up gear disconnected
D.only when the rudder is moved amidships
A.high temperature distillate can be re- circulated to induce additional flashing
B.scale formation is not a severe problem
C.cold shocking is more effective in removing scale
D.water purity is greatly increased at high capacity
A.high pressure liquid line
B.low pressure liquid line
C.high pressure vapor line
D.low pressure vapor line
A.more efficiently uses available engine power
B.operates at a lower efficiency at a fixed speed
C.produces the same torque at lower engine power
D.develops its rated power at a lower speed
A.more efficiently uses available engine power
B.operates at a lower efficiency at a fixed speed
C.produces the same torque at lower engine power
D.develops its rated power at a lower speed
A.Dissipate heat
B.Trap foreign matter
C.Separate air from the oil
D.All of the above
A.Dissipate heat
B.Trap foreign matter
C.Separate air from the oil
D.All of the above
A.Proper refrigerant charge
B.Faulty expansion valve
C.Insufficient refrigerant
D.Solenoid valve stuck open
最新试题
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
The major source of chemical contaminants in hydraulic fluid is （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.
Thermostatic expansion valves can be adjusted for （）.
Which of the listed pumps is NOT a positive displacement pump?（）
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
A salinity indicator is used to determine the （）.