A.Shortage of refrigerant oil
B.Slight shortage of refrigerant
C.Excessive condenser cooling water flow
D.Faulty expansion valve
您可能感兴趣的试卷
你可能感兴趣的试题
A.vary their speed according to temperature and load
B.start and come up to speed before air compression begins
C.change speed according to overload demands
D.reduce compressed air charge density
A.radiation
B.conduction
C.convection
D.condo-radiation
A.used in either the fully dosed or fully opened position
B.installed with the stem down
C.used for steam service only
D.used to throttle or regulate the flow of liquid
A.Radiation
B.Conduction
C.Natural convection
D.All of the above
A.A gate valve
B.A globe valve
C.Any check valve
D.Any needle valve
A.a shortage of compressor oil
B.warm food in the refrigerator
C.excessive condenser cooling water
D.a shortage of refrigerant
A.molecular fluid vibration
B.energy losses
C.wide pressure variations
D.mechanical damage to control valves
A.Keeps the refrigerated space cooler
B.Reduces the efficiency of the plant
C.Takes the load off the compressor
D.Has no affect on the system
A.proportional band
B.the error signal
C.the reset signal
D.feedback
A.Dehydrators must be used continuously in a refrigeration system
B.A 25 ton refrigeration system has the same cooling effect as melting 25 tons of ice in 24 hours
C.A thermostatic expansion valve is used to control refrigerated space temperature
D.The liquid receiver functions to collect and remove non- condensable gases
![](https://static.ppkao.com/ppmg/img/appqrcode.png)
最新试题
A salinity indicator is used to determine the ().
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?()
Who is responsible for ensuring that someone is assigned to close the watertight doors in an emergency?()
If the suction pressure at the refrigeration compressor is below normal, the cause can be().
Which of the following statements is correct concerning heat transfer?()
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
The control mode in which the final control element is moved from one of two flexed positions to the other is known as ().
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is ().
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will ().
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by ().