A.proper break-in wear
B.improper break-in wear
C.relocation of the overlay flashing
D.water contamination of the lube oil system
您可能感兴趣的试卷
你可能感兴趣的试题
A.water in the fuel
B.cold lube oil
C.excessive starting air pressure
D.excessive fuel pressure
A.fuel pump should be removed and all connections blanked off
B.cylinder oil feed rate should be increased slightly above that used at normal sea speed
C.cylinder oil feed rate should be reduced
D.cylinder oil feed rate should be increased to the maximum flow capable of the metering pump
A.the proper back pressure
B.the cooling water temperature
C.correct timing and proper seating
D.accurate metering and the exhaust temperature
A.low exhaust back pressure
B.air in the fuel system
C.gasket blow-by or leakage
D.incorrect assembly of idler springs
A.Hydraulic starting
B.Electric starting
C.Ignition
D.Fuel
A.pumping action of the piston
B.pressure of the fuel charge
C.vacuum developed in the manifold
D.pressure of the fresh air charge
A.Electric power and starting air
B.Lube oil standby pump and control air
C.Hydraulic switch and engage jacking gear
D.Motor drain and pneumatic control system power
A.engine overload
B.leaky valves
C.stuck or broken piston rings
D.low air injection pressure
A.Corrosion and eventual failure of the tank
B.Gumming of the tank relief valves
C.Immediate failure of components downstream of the compressed air system
D.Boiling of the water oil mixture as pressure is reduced
A.effective cylinder scavenging and cooling
B.constant pressure from the turbochargers
C.cooler operation of the exhaust system
D.effective constant pressure for turbocharger operation
最新试题
The condensers located in various stages of a flash evaporator are cooled by()
The main purpose of port State control is not to()
Which of the following items don’t belong to dock repair works?()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
The cetane rating of diesel fuel is an indication of the ()
The ISPS Code consists of a mandatory section-Part A, which shows()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the()