A.no VLANs
B.all VLANs
C.only VLANs 1 - 64
D.only the VLANs that are specified when creating the trunk
您可能感兴趣的试卷
你可能感兴趣的试题
A.It creates a VLAN 999 interface.
B.It designates VLAN 999 for untagged traffic.
C.It blocks VLAN 999 traffic from passing on the trunk.
D.It designates VLAN 999 as the default for all unknown tagged traffic.
A.It checks the configuration register.
B.It attempts to boot from a TFTP server.
C.It loads the first image file in flash memory.
D.It inspects the configuration file in NVRAM for boot instructions.
A.packet switching
B.access layer security
C.path selection
D.VLAN membership assignment
E.bridging between LAN segments
F.microsegmentation of broadcast domains
A.session
B.transport
C.network
D.data link
E.physical
A.protocol
B.VLAN number
C.TCP or UDP port numbers
D.source switch port number
E.source IP address and destination IP address
F.source MAC address and destination MAC address
A.BSS
B.ESS
C.IBSS
D.SSID
A.Because of damaged flash memory, the router will fail the POST
B.It will attempt to locate the IOS from a TFTP server. If this fails, it will initiate the setup dialog.
C.It will attempt to locate the IOS from a TFTP server. If this fails, it will load a limited IOS from ROM
D.It will attempt to locate the configuration file from a TFTP server. If this fails, it will initiate the setup dialog.
E.It will attempt to locate the configuration file from a TFTP server. If this fails, it will load a limited configuration from ROM
A.the summarized address for all of the internal subnetted addresses
B.the MAC address of the router used by inside hosts to connect to the Internet
C.a globally unique, private IP address assigned to a host on the inside network
D.a registered address that represents an inside host to an outside network
A.VTP allows routing between VLANs.
B.VTP allows a single port to carry information to more than one VLAN
C.VTP allows physically redundant links while preventing switching loops.
D.VTP allows switches to share VLAN configuration information.
A.point-to-point and multiaccess
B.point-to-multipoint and multiaccess
C.point-to-point and point-to-multipoint
D.nonbroadcast and broadcast multipoint
E.nonbroadcast and broadcast multiaccess
最新试题
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
Which statement is true, as relates to classful or classless routing?()
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()
At which layer of the OSI model is RSTP used to prevent loops?()
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()
Which command encrypts all plaintext passwords?()
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()