单项选择题While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()

A. Router#copy tftp flash
B. Router(config)#restore flash
C. Router(config)#repair flash
D. Router#copy flash run
E. Router>copy start flash
F. Router#copy start flash


您可能感兴趣的试卷

你可能感兴趣的试题

2.单项选择题An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()

A. IP address:192.168.20.14 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.9
B. IP address:192.168.20.254 Subnet Mask:255.255.255.0 Default Gateway:192.168.20.1
C. IP address:192.168.20.30 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.25
D. IP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.17
E. IP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.25

4.单项选择题

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()
Router(config)#router ospf 1
Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

A. The process id is configured improperly
B. The OSPF area is configured improperly
C. The network wildcard mask is configured improperly
D. The network number is configured improperly
E. The AS is configured improperly
F. The network subnet mask is configuerd improperly

5.单项选择题If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()

A. the IP address of the first Fast Ethernet interface
B. the IP address of the console management interface
C. the highest IP address among its active interfaces
D. the lowest IP address among its active interfaces
E. the priority value until a loopback interface is configured

7.单项选择题

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

A. Switch1(config)# i nterface fa0 /1 Switch1(config-if)# ip address 192.168.24.3.255.255.255.0
B. Switch1 (config)#interface fa0/1 Switch1 (config-if)# switchport mode trunk
C. Switch 1 (config)# i nterface fa0 /1 Switch1 (config-if)# duplex full Switch1 (config-if)# speed 100
D. Switch1 (config-if)# default-gateway 192.168.24.1
E. Switch1 (config)# line con 0 Switch1(config-line)# password cisco Switch1 (config-line)#login

8.单项选择题You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()

A. 192.168.252.8 255.255.255.248
B. 192.168.252.8 255.255.255.252
C. 192.168.252.16 255.255.255.240
D. 192.168.252.0 255.255.255.252
E. 192.168.252.16 255.255.255.252

9.单项选择题Which command displays the CHAP authentication process as it occurs between two routers?()

A. debug authentication
B. debug chap ppp
C. debug chap authentication
D. debug ppp authentication

10.单项选择题At which layer of the OSI model dose PPP perform?()

A. Layer 3
B. Layer 4
C. Layer 2
D. Layer 5

最新试题

What is the subnetwork address for a host with the IP address 201.100.5.68/28?()

题型:单项选择题

Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()

题型:单项选择题

Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()

题型:单项选择题

An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()

题型:单项选择题

Which pairing reflects a correct protocol-and-metric relationship?()

题型:单项选择题

A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()

题型:单项选择题

Which IPsec security protocol should be used when confidentiality is required?()

题型:单项选择题

Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()

题型:单项选择题

After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()

题型:单项选择题

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()

题型:单项选择题