A.disable Zone-Based Firewall as the two features are not compatible
B.disable Cisco Express Forwarding as the two features are not compatible
C.generate a certificate and export on Cisco.com to receive a signature update
D.import the public RSA key from the Cisco IPS team that allows the router to verify that a signatureupdate （which was signed by this key） comes from Cisco
您可能感兴趣的试卷
你可能感兴趣的试题
A. Add the command： router eigrp 1 traffic-share voice interface fast 0/0
B. Reconfigure EIGRP to recognize voice packets
C. Remove the variance from the configuration
D. Reconfigure the VoIP system to use RTP sequence number headers
E. Use an H '323 gatekeeper for your VoIP system to negotiate an H'245 uneven packet buffer
F. Reconfigure EIGRP to version 2
A.show ip pim rendez-vous
B.show ip rpf rp mapping
C.show ip pim rp mapping
D.show ip pim rp info
E.show ip pim
A.it enables PIM BSR
B.it makes the router an Auto-RP mapping agent
C.it advertises the router as an RP with Auto-RP
D.it makes the router an Auto-RP client
A.It will send the join only to the neighbor with the highest IP address.
B.It will send the join only to the neighbor with the lowest IP address.
C.It will send the join in a round-robin fashion across all neighbors.
D.It will send the join to all neighbors.
A.2001：db8：3811：：1
B.2001：db8：3811：：2323
C.2001：db8：3811：：0130
D.2001：db8：3811：：3
E.2001：db8：3811：：6
A.Flooding paths and redundancy
B.Amount of routing information in the OSPF area or routing domain
C.Number of routers with Cisco Express Forwarding enabled
D.Number of neighbor adjacencies
E.Other routing protocols in use
F.OSPF timer reconstruction negotiation
G.Redistribution with BGP neighbors
H.Redistribution with other IGP routing protocols， such as RIP or EIGRP
A. BGP peers must be Layer 2-adjacent
B. EBGP multihop is not configured
C. The firewall is not configured to allow IP protocol 89
D. The firewall is not configured to allow UDP 179.
Refer to the exhibit. Users on the 199.155.24.0 network are unable to reach the 172.16.10.0 network. What is the most likely solution？（）
A. Router ISP1 should be configured to peer with router B
B. Router ISP2 should be configured with no synchronization
C. Router ISP1 should be configured with no synchronization
D. Router ISP2 should be configured with no auto-summary.
E. Router ISP1 or IPS2 should be configured with network 176.16.10.0 mask 255.255.255.0
A.It relies on IPv6 to do the fragmenting.
B.It splits the LS Update packet into smaller packets.
C.It splits the LSA into smaller router LSA packets.
D.It produces an error.
Refer to the exhibit. Routers A and B are directly connected and running OSPF， but they are unable to form a neighbor relationship. What is the most likely cause？（）
A. The routers are not on the same network.
B. The network statements do not match.
C. The process number does not match.
D. The MTU does not match.
E. The OSPF cost does not match.
F. There is a physical issue with the cable.
最新试题
Choose two commands that are required to enable multicast on a router， when it is known that thereceivers use a specific functionality of IGMPv3.（）
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these？（）
The classic Spanning Tree Protocol （802.1 D 1998） uses which sequence of variables to determine thebest received BPDU？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）
Which of these statements about penultimate hop popping are true？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）
Which two statements about SA caching are true？（）
Which two are differences between IGMPv2 and IGMPv3 reports？（）
Which three message types are valid PIMv2 message types？（）