A.dropper
B.classifier
C.marker
D.querier
E.meter
F.shaper
您可能感兴趣的试卷
你可能感兴趣的试题
A.data marked with DSCP AF21，VOIP marked with DSCP EF
B.data marked with DSCP AF51，VOIP marked with DSCP EF
C.data marked with the DE-bit. VOIP marked with the CLP-bit
D.data marked with DSCP EF，VOIP marked with DSCP AF31
E.data marked with IP precedence 5，VOIP marked with DSCP EF
A.mark VOIP traffic with IP precedence 6 and configure only fair-queue’ on the links
B.configure the scheduler allocate 3000 1000 command to allow the OoS code to have enough CPU cycles
C.enable class-based traffic shaping on the VOIP traffic class
D.enable Layer 2 fragmentation and interleaving on the links
E.enable Frame Relay on the links and send voice and data on different Frame Relay PVCs
A.1） lowest root bridge id，2） lowest sender bridge id，3） lowest port id，4） lowest root path cost
B.1） lowest root path cost，2） lowest root bridge id，3） lowest sender bridge id，4） lowest sender port id
C.1） lowest root bridge id，2） lowest sender bridge id，3） lowest root path cost，4） lowest sender port id
D.1） lowest root bridge id，2） lowest root path cost，3） lowest sender bridge id，4） lowest sender port id
A.VTP updates are ignored and forwarded out all ports.
B.VTP updates are ignored and forwarded out trunks only.
C.VTP updates are made to the VLAN database and are forwarded out trunks only.
D.VTP updates are ignored and are not forwarded.
A.8192
B.16384
C.49152
D.65535
A.Designated Root Cost
B.bridge ID priority
C.max age
D.bridge ID MAC address
E.Designated Root Priority
F.forward delay
A.one global STP instance for all VLANs
B.one STP instance for each VLAN
C.one STP instance per set of VLANs
D.one STP instance per set of bridges
A.Attempt to TELNET from the router connected to the inside of the firewall to the router connected to theoutside of the firewall. If telnet works， BGP will work， since telnet and BGP both use TCP to transportdata.
B.Ping from the router connected to the inside interface of the firewall to the router connected to theoutside interface of the firewall. If you can ping between them， BGP should work， since BGP uses IP totransport packets.
C.There is no way to make BGP work across a firewall without special configuration， so there is no simpletest that will show you if BGP will work or not， other than trying to start the peering session.
D.There is no way to make BGP work across a firewall.
A.ip pim rp-address
B.ip pim ssm
C.ip pim sparse-mode
D.ip pim passive
A.MD5
B.There is no Type 0 authentication
C.SHA1
D.Null
最新试题
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
Which multicast address is reserved for cisco-rp-discovery？（）
Which three message types are valid PIMv2 message types？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
When STP UplinkFast is enabled on a switch utilizing the default bridge priority， what will the new bridgepriority be changed to？（）
Which of these statements about penultimate hop popping are true？（）
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group？（）
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）