A. >
B. #
C. ?
D. *
E. All of the above
F. None of the above
您可能感兴趣的试卷
你可能感兴趣的试题
A. Defines the network topology
B. Access to network resources
C. Routing and switching functions
D. Content Filtering
E. Intrusion Detection
A. show boot
B. show flash
C. show register
D. show version
E. show config
You are the administrator of the Testking network and you have forgotten the password to one of your routers. After completing the password recovery procedure the router returned to its normal operation. The config-register was set back to the initial default value.
What is this value?（）
A. 0x2112
B. 0x2104
C. 0x2102
D. 0x2142
E. 0x2100
A new switch is installed in the Testking network. This switch is to be configured sothat VLAN information will be automatically distributed to all the other Cisco Catalyst switches in the network.
Which of the conditions below have to be met in order for this to occur?（）
A. The switch that will share the VLAN information must be in the VTP Server mode.
B. The switches must be in the same VTP domain.
C. The switch that will share the VLAN information must be configured as the root bridge.
D. The switches must be configured to use the same VTP version.
E. The switches must be configured to use the same STP version.
F. The switches must be configured to use the same type of ID tagging.
G. The switches must be connected over VLAN trunks.
A. 802.1q forwarding
B. VTP transparent mode
C. Cut-through
D. Store-and-forward
E. Fragment-free
F. Frame-filtering
A. BPDU
B. Port security
C. RSTP
D. STP
E. VTP
F. Blocking mode
A. The additions will create more collision domains.
B. IP address utilization will be more efficient.
C. More bandwidth will be required than was needed previously.
D. An additional broadcast domain will be created.
E. The possibility that switching loops will occur will increase dramatically.
A. To prevent unauthorized Telnet access to a switch port.
B. To limit the number of Layer 2 broadcasts on a particular switch port.
C. To prevent unauthorized hosts from accessing the LAN.
D. To protect the IP and MAC address of the switch and associated ports.
E. To block unauthorized access to the switch management interfaces over common TCP ports.
A. All defined VLANs are allowed on the trunk by default.
B. Each VLAN, or VLAN range, that is specified with the switchport mode command.
C. Each VLAN, or VLAN range, that is specified with the vtp domain command.
D. Each VLAN, or VLAN range, that is specified with the vlan database command.
A. a straight-through cable
B. an EIA/TIA-232 serial cable
C. an auxiliary cable
D. a modem cable
E. a cross-over cable
最新试题
A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?（）
What is a global command?（）
What does a configuration Register Setting of 0x2105 indicate to the Router? （）
Which of the following options lists the steps in PPP session establishment in the correct order?（）
A Class C network address has been subnetted with a /27 mask.Which of the following addresses is a broadcast address for one of the resulting subnets?（）
Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. （）
Which of the following describe router functions?（）
Which of the following host addresses are member of networks that can be routed across the public Internet? （）
Which characteristics are representative of a link-state routing protocol?（）
All WAN links is side the TestKing.com network use PPP with for authentication security. Which command will display the CHAP authentication process as it occurs between two routers in the network?（）