A. Provide common view of entire topology
B. Exchange routing tables with neighbors.
C. Calculates shortest path.
D. Utilizes event triggered updates.
E. Utilizes frequent periodic updates.
您可能感兴趣的试卷
你可能感兴趣的试题
A. Use of full duplex mode.
B. Creation of new collision domain.
C. Creation of new broadcast domain.
D. Addition of hub to the network.
E. Use of switches in the network.
F. Amount of ARP or IPX SAP traffic.
A. Transport layer divides a data stream into segments & adds reliability & flow control information
B. Data link layer adds physical source & destination address & an FCS to the segment
C. Packets are created when the network layer encapsulate a frame with source & destination host address& protocol related control information
D. Packets are created when the network layers adds layers 3 address & control information to a segment
E. The presentation layer translated bits into bits into voltages for transmission across the physical link
A. The Boot IOS Code is Located in the NVRAM.
B. Check NVRAM for boot system Commands.
C. Bypass NVRAM Configurations.
D. Boot the IOS Code Located in ROM.
E. Perform a Password Recovery.
F. Bypass The Code In ROM.
A. show CHAP authentication
B. show interface serial 0
C. debug PPP authentication
D. debug CHAP authentication
E. show PPP authentication CHAP
A. 205.7.8. 32/27
B. 191.168. 10. 2/23
C. 127.0.0.1
D. 224.0.0.10
E. 203.123.45. 47/28
F. 10.10.0.0/13
A. 64 network and 4 hosts
B. 4 network and 64 hosts
C. 2 network and 62 hosts
D. 62 network and 2 hosts
A.TE1
B.TE2
C.NT1
D.NT2
A. 199.141.27.33
B. 199.141.27.112
C. 199.141.27.119
D. 199.141.27.126
E. 199.141.27.175
F. 199.141.27.208
A. The switch name must match the workgroup name of the local network.
B. The switch must be configured with an IP address and default gateway.
C. The remote workstations must have access to the management VLAN of the switch.
D. CDP must be enabled on the switch so that it can be located by other devices on the network.
A. show access-list
B. show ip route
C. show ip interface
D. show interface
E. show interface list
F. show ip interface brief
最新试题
Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?（）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? （）
You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?（）
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）
Which of the following if addresses can be assigned to host devices?（）
What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?（）
Which characteristics are representative of a link-state routing protocol?（）
Which connections allow the use of full-duplex Ethernet?（）
A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?（）