A. Use of full duplex mode.
B. Creation of new collision domain.
C. Creation of new broadcast domain.
D. Addition of hub to the network.
E. Use of switches in the network.
F. Amount of ARP or IPX SAP traffic.
您可能感兴趣的试卷
你可能感兴趣的试题
A. Transport layer divides a data stream into segments & adds reliability & flow control information
B. Data link layer adds physical source & destination address & an FCS to the segment
C. Packets are created when the network layer encapsulate a frame with source & destination host address& protocol related control information
D. Packets are created when the network layers adds layers 3 address & control information to a segment
E. The presentation layer translated bits into bits into voltages for transmission across the physical link
A. The Boot IOS Code is Located in the NVRAM.
B. Check NVRAM for boot system Commands.
C. Bypass NVRAM Configurations.
D. Boot the IOS Code Located in ROM.
E. Perform a Password Recovery.
F. Bypass The Code In ROM.
A. show CHAP authentication
B. show interface serial 0
C. debug PPP authentication
D. debug CHAP authentication
E. show PPP authentication CHAP
A. 205.7.8. 32/27
B. 191.168. 10. 2/23
C. 127.0.0.1
D. 224.0.0.10
E. 203.123.45. 47/28
F. 10.10.0.0/13
A. 64 network and 4 hosts
B. 4 network and 64 hosts
C. 2 network and 62 hosts
D. 62 network and 2 hosts
A.TE1
B.TE2
C.NT1
D.NT2
A. 199.141.27.33
B. 199.141.27.112
C. 199.141.27.119
D. 199.141.27.126
E. 199.141.27.175
F. 199.141.27.208
A. The switch name must match the workgroup name of the local network.
B. The switch must be configured with an IP address and default gateway.
C. The remote workstations must have access to the management VLAN of the switch.
D. CDP must be enabled on the switch so that it can be located by other devices on the network.
A. show access-list
B. show ip route
C. show ip interface
D. show interface
E. show interface list
F. show ip interface brief
A. To restart the router.
B. To bypass the configuration in NVRAM.
C. To view the lost password.
D. To save the changes to the configuration.
E. To enter ROM Monitor mode.
最新试题
Which statement describes the rule of split horizon?()
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?()
What is a global command?()
Which of the following options lists the steps in PPP session establishment in the correct order?()
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? ()
You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?()
Which of the following host addresses are member of networks that can be routed across the public Internet? ()
Which of the following correctly describe steps in the OSI data encapsulation process?()
What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?()
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? ()