A. Router(config-if)# encapsulation frame-relay q933a
B. Router(config-if)# encapsulation frame-relay ansi
C. Router(config-if)# encapsulation frame-relay ietf
D. Router(config-if)# encapsulation frame-relay isl
E. None of the above
您可能感兴趣的试卷
你可能感兴趣的试题
A. A successor route is used by EIGRP to forward traffic to a destination.
B. Successor routes are saved in the topology table to be used if the primary route fails.
C. Successor routes are flagged as "active" in the routing table.
D. A successor route may be backed up by a feasible successor route.
E. Successor routes are stored in the neighbor table following the discovery process.
F. Successors are not used in EIGRP.
A. Show interface lmi
B. Show frame-relay lmi
C. Show interface frame-relay
D. Debug frame-relay interface.
A. EIA/TIA
B. Q.932
C. Q.933A
D. IEEE
E. Cisco
F. Annex D
A.serialup
B.clock
C.clockrate
D.dcerate
E.dterate
A. Nothing. The router is already suitable.
B. A BRI WAN interface in the router.
C. An external NT1 to terminate the local loop.
D. A TA/NT1 device on the router.
A. Q.931
B. IPCP
C. multilink
D. CHAP
E. callback
A.SSL
B.SLIP
C.PAP
D.LAPB
E.CHAP
F.VNP
A. TestKRouter(config-if)# Encapsulation frame-relay dot1q
B. TestKRouter(config-if)# Encapsulation frame-relay aal5snap
C. TestKRouter(config-if)# Encapsulation frame-relay ietf
D. TestKRouter(config-if)# Encapsulation frame-relay isl
E. None of the above
A. frame-relay arp
B. frame-relay map
C. frame-relay interface-dlci
D. frame-relay lmi-type
E. frame-relay pvc
A. The local DLCI on each subinterface of the Frame Relay.
B. The Frame Relay encapsulation on the physical interface.
C. An IP address on the physical interface.
D. The subinterface type as point-to-point
最新试题
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? ()
What is the subnetwork address for a host with IP address 201.100.5.68/28?()
New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? ()
Which of the following describe router functions?()
How many usable sub network and usable hosts per subnet result in the network address 201.105.13.0 is sub netted with a mask of /26? ()
What is a global command?()
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? ()
A Class C network address has been subnetted with a /27 mask.Which of the following addresses is a broadcast address for one of the resulting subnets?()
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?()
Which of the following options lists the steps in PPP session establishment in the correct order?()