A. A routing protocol is assigned to an interface and determines the method of packet delivery.
B. A routed protocol is assigned to an interface and determines the method of packet delivery.
C. A routing protocol determines the path of a packet through a network.
D. A routed protocol determines the path of a packet through a network.
E. A routing protocol operates at the transport layer of the OSI model.
F. A routed protocol updates the routing table of a router.
您可能感兴趣的试卷
你可能感兴趣的试题
A. source MAC address
B. source IP address
C. source switch port
D. destination IP address
E. destination port address
F. destination MAC address
A. The frame is dropped.
B. The frame is addressed with a broadcast MAC address and sent out all ports.
C. The frame is sent out all ports except the receiving port.
D. An ARP request is sent out all ports except the receiving port.
E. A destination unreachable message is sent back to the source address.
F. None of the above.
A. A device waits for an electronic signal before transmitting.
B. A device listens and waits until the media is not busy before transmitting.
C. All devices on an Ethernet segment see data that passes on the network medium.
D. Only the sender and the receiver devices see data that passes on the network medium.
E. Ethernet networks allow you to configured devises with higher transmission priority.
A. Hosts use a logical ring topology.
B. Hosts use a logical bus topology
C. Hosts must wait for an electronic signal to transfer data.
D. Hosts are directly connected to a wiring concentrator called a MSAU.
A. Each device on the Ethernet segment stops transmitting for a short time.
B. A jam signal informs all devices that a collision occurred.
C. When data transmission resumes, the devices that were involved in the collision have priority to transmit.
D. The devices that are involved in the collision stops transmitting for a short time.
E. The collision invokes a random back-off algorithm.
A.172.31.128.255./18
B.255.255.255.255
C.192.168.24.59/30
D.224.0.0.5
E.All of the above
A. Gateway DP
B. Reverse ARP
C. proxy ARP
D. Inverse ARP
E. indirect ARP
A. Inverse-ARP
B. Reverse-ARP
C. Proxy ARP
D. ARP
A. near-end crosstalk(NEXT)
B. middle open-end crosstalk(MOEXT)
C. power sum near-end crosstalk(PSNEXT)
D. jitterry crosstalk(JEXT)
E. far end crosstalk(FEXT)
A.100 meters
B.100 feet
C.100 yards
D.200 meters
最新试题
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? （）
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?（）
What is the subnetwork address for a host with IP address 201.100.5.68/28?（）
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? （）
Which of the following host addresses are member of networks that can be routed across the public Internet? （）
Which command is used to display the placement and direction of an IP access control list on a router?（）
Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?（）
Which of the following options lists the steps in PPP session establishment in the correct order?（）
A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? （）
Which Frame Relay feature is responsible for transmitting keepalives to ensure that the PVC does not shut down because of inactivity?（）