A.two
B.three
C.four
D.one
您可能感兴趣的试卷
你可能感兴趣的试题
On a cisco aironet 1230 series autonomous access point, the status led is solid red, and the ethernet and radio leds are both off.
What does this indicate?()
A.a firmware upgrade is in progress.
B.the internal radio has failed.
C.an access point buffer overflow is occurring.
D.the access point is booting.
A.8
B.32
C.4
D.16
On a cisco aironet 1130 series autonomous access point, the status indicator is blinking dark blue.
What does this indicate?()
A.the access point is booting.
B.a firmware upgrade is in progress.
C.the internal radio has failed.
D.an access point buffer overflow is occurring.
Scalability: with the cisco wireless location appliance, 2500 devices including wireless clients or wi-fi tags can be tracked simultaneously, helping ensure that location services can be applied to an entire enterprise environment.
Which of the following functions on the wireless lan controller is used to determine whether or not a rogue access point is connected to the same layer 2 network?()
A.rogue detector
B.rogue containment
C.rldp
D.ridp
A.1000
B.2000
C.2500
D.1500
You are troubleshooting a problem with a cisco 7920 wireless ip phone on a standalone wlan. the phone rings but, when you Answer ,the call is dropped.
What may have caused this problem?()
A.publicly secure packet forwarding is enabled.
B.the minimum data rate is not set to 11 mbps.
C.an address resolution protocol is enabled.
D.the access point is set to the least congested channel.
A cisco wcs version 4.0 has been installed on a server with a dual pentium 3.0 ghz processor,4 gb ram,and an 80 gb hard drive. a location appliance has been incorporated into the network and is being monitored by the cisco wcs. there are 3000 devices to be tracked but not all of them are being tracked on the cisco wcs.
What can be done to correct the problem?()
A.add a new location appliance.
B.add a new cisco wcs server dedicated to the location appliance.
C.add 4 gb of ram to the cisco wcs.
D.add a 120 gb hard drive to the cisco wcs.
You are troubleshooting a problem with a cisco 7920 wireless ip phone that is causing the phone to drop calls. the problem appears to be a roaming bandwidth issuE. in order to verify what kind of issue it is, you decide to increase the bandwidth reserved for roaming on the wlan controller to the maximum.
What level do you set the bandwidth to?()
A.25 percent
B.15 percent
C.5 percent
D.35 percent
Using the wlse, you are trying to push out a configuration job to a standalone access point, but the job does not start.
Which of the following would cause this failure?()
A.invalid parameter in the template
B.incorrect snmp communities on the access point
C.pop-up blocker enabled in the browser
D.unsupported version of ios firmware in the access point
A.1000
B.1500
C.2000
D.2500
最新试题
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port?()
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add?()
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS? ()
Which of the following accurately represents the functionality of a lightweight access point configured to operate in sniffer AP mode?()
On a Cisco Aironet 1240AG Series standalone access point, the radio LED is dark blue and blinking,but the status LED and Ethernet LED are both off.What does this indicate?()
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast?()
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but, when you answer, the call is dropped.What may cause this problem?()
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it, allthe LEDs on the access point blink together.What does this indicate about the access point?()
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage?()
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it, which continue to pass traffic.What has causedthis problem?()