A.damage to the un-loader operating diaphragm
B.an increase in current flow to the motor
C.high pressure in the receiver and filter
D.an excessive consumption of crankcase oil
您可能感兴趣的试卷
你可能感兴趣的试题
A.first stage
B.second stage
C.distillate cooler
D.salt water feed heater
A.Gravity siphon effect
B.Higher vacuum in the second-stage
C.Difference in brine density between first and second stages
D.lower pressure in first-stage
A.decreased compression ratio
B.higher than normal power consumption
C.un-loader malfunction
D.water in the lubricating oil
A.reduce friction between moving surfaces
B.provide even distribution of bearing wear
C.reduce the accumulation of harmful detergents
D.maintain a constant oil temperature output at each beating
A.vapor feed heater
B.air ejector condenser
C.saltwater heater
D.distillate cooler
A.ballast tanks
B.sludge tanks
C.machinery space bilges
D.cargo hold bilges
A.excessive drive motor speed
B.excessive pump discharge pressure
C.too low of a tilting box angle
D.insufficient drive motor speed
A.high pressure liquid
B.low pressure vapor
C.high pressure vapor
D.low pressure liquid
A.propeller hub
B.lignum vitae
C.shaft packing
D.labyrinth seal
A.liquid
B.dry saturated gas
C.wet saturated gas
D.superheated vapor
最新试题
Thermostatic expansion valves can be adjusted for （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
The general purpose of a heat exchanger is to （）.
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?（）
The major source of chemical contaminants in hydraulic fluid is （）.
Which of the following statements is correct concerning heat transfer?（）
A grease gun is generally used to lubricate a （）.