A.Gravity siphon effect
B.Higher vacuum in the second-stage
C.Difference in brine density between first and second stages
D.lower pressure in first-stage
您可能感兴趣的试卷
你可能感兴趣的试题
A.decreased compression ratio
B.higher than normal power consumption
C.un-loader malfunction
D.water in the lubricating oil
A.reduce friction between moving surfaces
B.provide even distribution of bearing wear
C.reduce the accumulation of harmful detergents
D.maintain a constant oil temperature output at each beating
A.vapor feed heater
B.air ejector condenser
C.saltwater heater
D.distillate cooler
A.ballast tanks
B.sludge tanks
C.machinery space bilges
D.cargo hold bilges
A.excessive drive motor speed
B.excessive pump discharge pressure
C.too low of a tilting box angle
D.insufficient drive motor speed
A.high pressure liquid
B.low pressure vapor
C.high pressure vapor
D.low pressure liquid
A.propeller hub
B.lignum vitae
C.shaft packing
D.labyrinth seal
A.liquid
B.dry saturated gas
C.wet saturated gas
D.superheated vapor
A.closed, and no leakage permitted across the shaft packing
B.closed, and only slight leakage permitted across the shaft packing
C.open, and no leakage permitted across the shaft packing
D.open, and only slight leakage permitted across the shaft packing
A.freezing point
B.floc point
C.condensing temperature
D.compression temperature
最新试题
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
Low compressor head pressure in a refrigeration system can be caused by（）.
A grease gun is generally used to lubricate a （）.
Which of the following statements is correct concerning heat transfer?（）
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
The output volume of a positive fixed displacement pump can be changed only by （）.