A.increase the starting air pressure
B.use a higher than normal cranking speed
C.increase the fuel injection pressure
D.use a fuel having a lower ignition temperature
您可能感兴趣的试卷
你可能感兴趣的试题
A.soft water pump was not secured along with the engine
B.jacket water thermostat has failed
C.cylinder liner may be cracked
D.raw water pump is over-speeding just prior to engine shutdown
A.excessive fuel pressure
B.high lube oil viscosity
C.inadequate fuel injection
D.excessive starting air pressure
A.proper break-in wear
B.improper break-in wear
C.relocation of the overlay flashing
D.water contamination of the lube oil system
A.water in the fuel
B.cold lube oil
C.excessive starting air pressure
D.excessive fuel pressure
A.fuel pump should be removed and all connections blanked off
B.cylinder oil feed rate should be increased slightly above that used at normal sea speed
C.cylinder oil feed rate should be reduced
D.cylinder oil feed rate should be increased to the maximum flow capable of the metering pump
A.the proper back pressure
B.the cooling water temperature
C.correct timing and proper seating
D.accurate metering and the exhaust temperature
A.low exhaust back pressure
B.air in the fuel system
C.gasket blow-by or leakage
D.incorrect assembly of idler springs
A.Hydraulic starting
B.Electric starting
C.Ignition
D.Fuel
A.pumping action of the piston
B.pressure of the fuel charge
C.vacuum developed in the manifold
D.pressure of the fresh air charge
A.Electric power and starting air
B.Lube oil standby pump and control air
C.Hydraulic switch and engage jacking gear
D.Motor drain and pneumatic control system power
![](https://static.ppkao.com/ppmg/img/appqrcode.png)
最新试题
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
The main purpose of port State control is not to()
The condensers located in various stages of a flash evaporator are cooled by()
The treatment of the fuel oils involves storage, heating, filtering and()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Cold weather starting of a diesel engine may be made easier by()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()