您可能感兴趣的试卷
你可能感兴趣的试题
A.150.150.0.0
B.150.150.0.8
C.150.150.8.0
D.150.150.16.0
A.Network A - 172.16.3.48/26
B.Network A - 172.16.3.128/25
C.Network A - 172.16.3.192/26
D.Link A - 172.16.3.0/30
E.Link A - 172.16.3.40/30
F.Link A - 172.16.3.112/30
The switches shown in the diagram, Core and Core2, are both Catalyst 2950s. The addressing scheme for each company site is as follows:Router Ethernet port - 1st usable addressCore - 2nd usable addressCore2 - 3rd usable addressFor this network, which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet on the network? ()
A.Core2(config)# interface f0/0 Core2(config-if)# ip address 192.168.1.10 255.255.255.248
B.Core2(config)# interface vlan 1 Core2(config-if)# ip address 192.168.1.11 255.255.255.248
C.Core2(config)# line con 0 Core2(config-line)# password cisco
D.Core2(config)# line vty 0 4 Core2(config-line)# password cisco
E.Core2(config)# ip default-gateway 192.168.1.9
F.Core2(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.8
A.a primary route,stored in the routing table
B.a backup route,stored in the routingt able
C.a backup route,stored in the topology table
D.A primary route,stored in the topology table
A.子网掩码
B.源网络地址
C.目的网络地址
D.下一跳地址
A.应用层
B.表示层
C.会话层
D.传输层
E.网络层
F.链路层
G.物理层
A.the session layer
B.the protocol layer
C.the data link layer
D.the access layer
E.the network layer
F.the application layer
A.It supports VLSM.
B.It is used to route between autonomous systems.
C.It confines network instability to one area of the network.
D.It increases routing overhead on the network.
E.It allows extensive control of routing updates.
F.It is simpler to configure than RIP v2.
A.Router C will use ICMP to inform Host 1 that Host 2 cannot be reached
B.Router C will use ICMP to inform Router B that Host 2 cannot be reached
C.Router C will use ICMP to inform Host 1, Router A, and Router B that Host 2 cannot be reached
D.Router C will send a Destination Unreachable message type
E.Router C will send a Router Selection message type
F.Router C will send a Source Quench message type
最新试题
下列哪些是私有IP 地址的地址范围?()
请参见图示。某用户想要查看当前的配置。图中所示为ipconfig/all 命令的输出。从此输出可以得到哪三项结论?()
请参见图示。下列哪组设备仅包含中间设备?()
要将数据包发送到远程网络,应使用哪种设备?()
在配置路由器时,网络技术人员想要命名路由器。输入hostname 命令后,技术人员会看到下列哪一项提示?()
请参见图示。网络技术人员使用图中所示的连接将主机A 连接到路由器以创建初始配置。下列有关此连接的陈述中哪一项正确?()
请参见图示。网络技术人员试图确定主机A 的正确IP 地址配置。以下哪一项是主机A 的有效配置?()
请参见图示。从主机X 发出的到主机Y 的tracert 命令已成功。下列哪一项正确地反映了追踪列表中显示的中间网络设备的顺序?()
传输层如何让主机能同时针对不同应用程序维护多个通信流?()
请参见图示。当计算机A 向计算机D 发送帧时,哪些计算机会接收该帧?()