A.A CSU/DSU terminates a digital local loop.
B.A modem terminates a digital local loop.
C.A CSU/DSU terminates an analog local loop.
D.A modem terminates an analog local loop.
E.A router is commonly considered a DTE device.
F.A router is commonly considered a DCE device.
您可能感兴趣的试卷
你可能感兴趣的试题
A.Switches are primarily software based while bridges are hardware based.
B.Both bridges and switches forward Layer 2 broadcasts.
C.Bridges are frequently faster than switches.
D.Switches have a higher number of ports than most bridges.
E.Bridges define broadcast domains while switches define collision domains.
F.Both bridges and switches make forwarding decisions based on Layer 2 addresses.
A.addresses chosen by a company to communicate with the Internet
B.addresses that cannot be routed through the public Internet
C.addresses that can be routed through the public Internet
D.a scheme to conserve public addresses
E.addresses licensed to enterprises or ISPs by an Internet registry organization
A.during high traffic periods
B.after broken links are re-established
C.when upper-layer protocols require high reliability
D.in an improperly implemented redundant topology
E.when a dual ring topology is in use
A.TFTP server, Flash, NVRAM
B.ROM, NVRAM, TFTP server
C.NVRAM, TFTP server, ROM
D.Flash, TFTP server, ROM
E.Flash, NVRAM, ROM
A.Filtering can occur based on Layer 3 information.
B.Broadcasts are eliminated.
C.Routers generally cost less than switches.
D.Broadcasts are not forwarded across the router.
E.Adding a router to the network decreases latency.
A.The PC has connectivity with a local host.
B.The PC has connectivity with a Layer 3 device.
C.The PC has a default gateway correctly configured.
D.The PC has connectivity up to Layer 5 of the OSI model.
E.The PC has the TCP/IP protocol stack correctly installed.
A.It creates a global address pool for all outside NAT transactions.
B.It establishes a dynamic address pool for an inside static address.
C.It creates dynamic source translations for all inside local PAT transactions.
D.It creates a one-to-one mapping between an inside local address and an inside global address.
E.It maps one inside source address to a range of outside global addresses.
A.VLAN support
B.compression
C.authentication
D.sliding windows
E.multilink support
F.quality of service
A.It specifies use of a static encryption key that must be changed frequently to enhance security.
B.It requires use of an open authentication method.
C.It specifies the use of dynamic encryption keys that change each time a client establishes a connection.
D.It requires that all access points and wireless devices use the same encryption key.
E.It includes authentication by PSK
A.Configure a separate sub-interface for each PVC with a unique DLCI and subnet assigned to the sub-interface.
B.Configure each Frame Relay circuit as a point-to-point line to support multicast and broadcast traffic.
C.Configure many sub-interfaces on the same subnet.
D.Configure a single sub-interface to establish multiple PVC connections to multiple remote router interfaces.
最新试题
Which command is used to display the collection of OSPF link states?（）
Which statement is true, as relates to classful or classless routing?（）
At which layer of the OSI model is RSTP used to prevent loops?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
At which layer of the OSI model dose PPP perform?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
Which command encrypts all plaintext passwords?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）