A.RIP version 1 broadcasts updates whereas RIP version 2 uses multicasts.
B.RIP version 1 multicasts updates while RIP version 2 uses broadcasts.
C.Both RIP version 1 and RIP version 2 are classless routing protocols.
D.RIP Version 2 is a classless routing protocol whereas RIP version 1 is a classful routing protocol.
E.Both RIP version 1 and version 2 support authentication.
F.RIP version 2 sends the subnet mask in updates and RIP version 1 does not.
您可能感兴趣的试卷
你可能感兴趣的试题
A.no VLANs
B.all VLANs
C.only VLANs 1 - 64
D.only the VLANs that are specified when creating the trunk
A.It creates a VLAN 999 interface.
B.It designates VLAN 999 for untagged traffic.
C.It blocks VLAN 999 traffic from passing on the trunk.
D.It designates VLAN 999 as the default for all unknown tagged traffic.
A.It checks the configuration register.
B.It attempts to boot from a TFTP server.
C.It loads the first image file in flash memory.
D.It inspects the configuration file in NVRAM for boot instructions.
A.packet switching
B.access layer security
C.path selection
D.VLAN membership assignment
E.bridging between LAN segments
F.microsegmentation of broadcast domains
A.session
B.transport
C.network
D.data link
E.physical
A.protocol
B.VLAN number
C.TCP or UDP port numbers
D.source switch port number
E.source IP address and destination IP address
F.source MAC address and destination MAC address
A.BSS
B.ESS
C.IBSS
D.SSID
A.Because of damaged flash memory, the router will fail the POST
B.It will attempt to locate the IOS from a TFTP server. If this fails, it will initiate the setup dialog.
C.It will attempt to locate the IOS from a TFTP server. If this fails, it will load a limited IOS from ROM
D.It will attempt to locate the configuration file from a TFTP server. If this fails, it will initiate the setup dialog.
E.It will attempt to locate the configuration file from a TFTP server. If this fails, it will load a limited configuration from ROM
A.the summarized address for all of the internal subnetted addresses
B.the MAC address of the router used by inside hosts to connect to the Internet
C.a globally unique, private IP address assigned to a host on the inside network
D.a registered address that represents an inside host to an outside network
A.VTP allows routing between VLANs.
B.VTP allows a single port to carry information to more than one VLAN
C.VTP allows physically redundant links while preventing switching loops.
D.VTP allows switches to share VLAN configuration information.
最新试题
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()
Which IPsec security protocol should be used when confidentiality is required?()
How are VTP advertisements delivered to switches across the network?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()
What is the subnetwork address for a host with the IP address 201.100.5.68/28?()
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()
On which options are standard access list based?()
Which pairing reflects a correct protocol-and-metric relationship?()
At which layer of the OSI model dose PPP perform?()