A.transparent
B.auto
C.on
D.desirable
E.blocking
F.forwarding
您可能感兴趣的试卷
你可能感兴趣的试题
A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.
B.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.
D.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.
A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio
A.VTP
B.STP
C.ISL
D.802.1Q
E.VLSM
A.buffering
B.cut-through
C.windowing
D.congestion avoidance
E.load balancing
A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 5
E.Layer 6
F.Layer 7
A.By default， all defined VLANs are allowed on the trunk.
B.Each single VLAN， or VLAN range， must be specified with the switchport mode command.
C.Each single VLAN， or VLAN range， must be specified with the vtp domain command.
D.Each single VLAN， or VLAN range， must be specified with the vlan database command.
A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.
A.A WPA key is longer and requires more special characters than the WEP key.
B.The access point and the client are manually configured with different WPA key values.
C.WPA key values remain the same until the client configuration is changed.
D.The values of WPA keys can change dynamically while the system is used.
A.The router will use the static route.
B.The router will use the OSPF route.
C.The router will use the EIGRP route.
D.The router will load balance and use all three routes.
A.neighbor table
B.SPF table
C.RTP table
D.topology table
E.query table
F.DUAL table
最新试题
Which command is used to display the collection of OSPF link states?（）
How are VTP advertisements delivered to switches across the network?（）
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?（）
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）