A.ip route 0.0.0.0 0.0.0.0 s0/0/0
B.ip route 0.0.0.0 0.0.0.0 209.165.200.226
C.ip route 209.165.200.0 255.255.255.0 192.168.1.250
D.ip route 192.168.1.0 255.255.255.0 209.165.100.250
您可能感兴趣的试卷
你可能感兴趣的试题
A.using adapters and access points manufactured by the same company
B.overlapping the wireless cell coverage by at least 10%
C.configuring all access points to use the same channel
D.utilizing MAC address filtering to allow the client MAC address to authenticate with the surrounding APs
A.AES-CCMP
B.PPK via IV
C.PSK
D.TKIP/MIC
A.transparent
B.auto
C.on
D.desirable
E.blocking
F.forwarding
A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.
B.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.
D.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.
A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio
A.VTP
B.STP
C.ISL
D.802.1Q
E.VLSM
A.buffering
B.cut-through
C.windowing
D.congestion avoidance
E.load balancing
A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 5
E.Layer 6
F.Layer 7
A.By default， all defined VLANs are allowed on the trunk.
B.Each single VLAN， or VLAN range， must be specified with the switchport mode command.
C.Each single VLAN， or VLAN range， must be specified with the vtp domain command.
D.Each single VLAN， or VLAN range， must be specified with the vlan database command.
A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.
最新试题
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
At which layer of the OSI model is RSTP used to prevent loops?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
Which command is used to display the collection of OSPF link states?（）
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）
What is the default administrative distance of OSPF?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0