A.EBGP multihop will need to be configured for this to work.
B.This should work with normal BGP peering, with no additional configuration on the BGP speakers or the firewall.
C.The BGP protocol port must be opened on the firewall
D.There is no way to make BGP work across a firewall.
您可能感兴趣的试卷
你可能感兴趣的试题
A.The stack bit will only be used when LDP is the label distribution protocol
B.The label is the last entry in the label stack.
C.The stack bit is for Cisco implementations exclusively and will only be used when TDP is the label distribution protocol.
D.The stack bit is reserved for future use.
A.Reverse Path Forwarding
B.Hardware-based forwarding
C.UDP forwarding
D.Layer 2 Forwarding
A.The firewall does not support Cisco Discovery Protocol. You should set the switchport trunk mode ON
B.The firewall does not support Cisco Discovery Protocol. You should set the switchport trunk mode to OFF
C.The firewall does not support Cisco Discovery Protocol. You should set the switchport trunk mode asauto.
D.The firewall does not support DTP. You should set the switchport trunk mode to ON
A.0.0.0.1
B.0.255.0.1
C.2001:DB8::1
D.2001:DB8:ABCD:FEEF::1
A.excessive collisions
B.FCS errors
C.runts
D.late collisions
A.BPDUs that enter a blocking port are discarded.
B.BPDUs that enter a blocking port are processed.
C.Loopguard puts an interface into a loop-inconsistent state when BPDUs stop being received on a blocking port.
D.BPDUs are only processed on forwarding ports.
A.The CBWFQ scheduler provides a guaranteed minimum amount of bandwidth to each class.
B.CBWFQ services each class queue using a strict priority scheduler.
C.The class-default queue only supports WFQ.
D.Inside a class queue, processing is always FIFO, except for the class-default queue.
A.It is a function used by routing protocols to install routes into routing table
B.It is a function that prevents the advertising of routes over an interface that the router is usingto reach a route
C.Its function is to help avoid routing loops.
D.It is a redistribution technique used by routing protocols
A.An update packet with init flag set from a known, already established neighbor relationship was received by one of the routers.
B.The counters were deleted.
C.The ARP cache was removed.
D.The IP EIGRP neighbor relationship was cleared manually.
A.Area 0
B.NSSA
C.Totally stubby
D.Stub
最新试题
You are the network administrator of an enterprise company that just deployed a global IP telephony environment. In order to guarantee good voice quality, you asked your provider to implement QoS on the CE routers of your MPLS network. On your LAN, you have also deployed QoS. Users, however, keep complaining about bad voice quality, and the provider does not see matches on the DSCP values that you have asked him to match upon. What is most likely the problem?()
In GLBP, which router will answer on client ARP requests?()
What does a unicast prefix-based IPv6 multicast address start with?()
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message (knowing that the MSDP router is also configured as an RP for the PIM domain)?()
For the following protocols, which one provides a mechanism to transparently intercept and redirect CIFS traffic from a client to a local Cisco Wida Area Application engine?()
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link, but only allow each individual flow to use 1 MB/s?()
You are the network administrator of a Layer 3 switched network. Users in one VLAN are complaining that access to the server VLAN is very slow from time to time. Traffic in the local VLAN works without any issue, and users in other VLANs do not have any complaint to reach the server VLAN. What is most likely the cause of this issue?()
Two directly connected routers, R1 and R2, are both configured for OSPF graceful restart. R2 is able to switch packets in hardware, but R1 is not. If a network administrator logs on to R2 and performs a system reload, which will be the result?()
Policy-based routing allows network administrators to implement routing policies to allow or deny paths based on all of these factors except which one?()
Choose two commands that are required to enable multicast on a router, when it is known that the receivers use a specific functionality of IGMPv3.()