A. server
B. client
C. tunnel
D. transparent
您可能感兴趣的试卷
你可能感兴趣的试题
A. show mac-address
B. show arp
C. show table
D. show switchport
A. show command
B. debug command
C. configuration command
D. rommon command
A. 8 subnets, 31 hosts
B. 8 subnets, 32 hosts
C. 16 subnets, 30 hosts
D. 16 subnets, 32 hosts
E. A Class B address can't be subnetted into the fourth octet.
Users have been complaining that their Frame Relay connection to the corporate site is very slow. The network administrator suspects that the link is overloaded. Based on the partial output of the Router# show frame relay pvc command shown in the graphic, which output value indicates to the local router that traffic sent to the corporate site is experiencing congestion?()
A. DLCI = 100
B. last time PVC status changed 00:25:40
C. in BECN packets 192
D. in FECN packets 147
E. in DE packets 0
A. 131.1.123.30
B. 131.1.123.31
C. 131.1.123.32
D. 131.1.123.33
A. show chap authentication
B. show interface serial0
C. debug ppp authentication
D. debug chap authentication
E. show ppp authentication chap
A. Router# show ip eigrp adjacency
B. Router# show ip eigrp topology
C. Router# show ip eigrp interfaces
D. Router# show ip eigrp neighbors
A. A WPA key is longer and requires more special characters than the WEP key.
B. The access point and the client are manually configured with different WPA key values.
C. WPA key values remain the same until the client configuration is changed.
D. The values of WPA keys can change dynamically while the system is used.
A. Set the SSID value in the client software to public.
B. Configure open authentication on the AP and the client.
C. Set the SSID value on the client to the SSID configured on the AP.
D. Configured MAC address filtering to permit the client to connect to the AP.
A. AES
B. PSK
C. SSID
D. TKIP
E. WEP
最新试题
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()
Which IPsec security protocol should be used when confidentiality is required?()
At which layer of the OSI model dose PPP perform?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()