There are 2 switches in the Testking LAN, with no routers. Ports 1, 2 & 3 are assigned to VLAN 1 in switch 1 and 2 and ports 4, 5 & 6 are assigned to VLAN 2 in both switches. These two switches are connected together via a trunked link.
Which of the conditions below would verify trunk and VLAN operation?()
A. Host 1 on VLAN 1 can ping Host 2 on VLAN 1
B. Host 1 on VLAN 1 can ping Host 4 on VLAN 2
C. Host 1 on VLAN 1 can not ping Host 2 on VLAN 1
D. Host 4 on VLAN 2 can not ping Host 1 on VLAN 1
E. Host 4 on VLAN 2 can ping Host 2 on VLAN 2
您可能感兴趣的试卷
你可能感兴趣的试题
A TestKing.com technician is troubleshooting connectivity problems between two routers that are directly connected through the serial line. The technician notices that the serial line is up but cannot see any neighbors displayed in the output of the show cdp neighbors command.
In which OSI layer is the problem most likely occurring?()
A. Physical
B. Data link
C. Network layer
D. Transport layer
E. Application layer
A.Application
B.Presentation
C.Session
D.Transport
E.Network
F.Data-Link
A. Application
B. Presentation
C. Session
D. Transport
E. Internet
F. Data Link
G. Physical
A. The data link layer
B. The application layer
C. The access layer
D. The session layer
E. The network layer
A. show ip links
B. show cdp neighbor
C. show cdp neighbor detail
D. show ip clients
E. show ip route
F. None of the above
A. to identify valid numbers for incoming calls
B. to define the type of ISDN switch at the central office
C. to specify the list of outgoing phone numbers used by the router
D. to associate a dial configuration with a physical interface
E. to define interesting traffic that will enable the link
A. Router(config-if)# encapsulation frame-relay q933a
B. Router(config-if)# encapsulation frame-relay ansi
C. Router(config-if)# encapsulation frame-relay ietf
D. Router(config-if)# encapsulation frame-relay isl
E. None of the above
A. A successor route is used by EIGRP to forward traffic to a destination.
B. Successor routes are saved in the topology table to be used if the primary route fails.
C. Successor routes are flagged as "active" in the routing table.
D. A successor route may be backed up by a feasible successor route.
E. Successor routes are stored in the neighbor table following the discovery process.
F. Successors are not used in EIGRP.
A. Show interface lmi
B. Show frame-relay lmi
C. Show interface frame-relay
D. Debug frame-relay interface.
A. EIA/TIA
B. Q.932
C. Q.933A
D. IEEE
E. Cisco
F. Annex D
最新试题
Which of the following contribute to congestion on an Ethernet network?()
What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?()
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? ()
All WAN links is side the TestKing.com network use PPP with for authentication security. Which command will display the CHAP authentication process as it occurs between two routers in the network?()
New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? ()
Which of the following options lists the steps in PPP session establishment in the correct order?()
What is the subnetwork address for a host with IP address 201.100.5.68/28?()
What feature of a networks switch allows an administrative to create separate broadcast domains?()
A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? ()
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? ()