A.router（config-ssid）# enable
B.router（config-ssid）# advertise
C.router（config-ssid）# broadcast
D.router（config-ssid）# guest-mode
您可能感兴趣的试卷
你可能感兴趣的试题
A.cisco aironet 1500 series
B.cisco aironet 1400 series
C.cisco aironet 1300 series
D.cisco aironet 1200 series
You review the failed attempts logs on an aaa server and find： "unknown network access server error."
Which failure could produce this error？（）
A.failure of the wireless client and aaa server handshake
B.supplicant authentication failure
C.aaa client and aaa server handshake
D.wrong password used by the supplicant
You are troubleshooting a problem with a cisco 7920 wireless ip phone that is causing the phone to drop calls. the problem appears to be roaming bandwidth issuE. in order to verify what kind of issue it is， you decide to increase the bandwidth reserve for roaming on the wlan controller to maximum.
What level do you set the bandwidth to？（）
A.5 percent
B.15 percent
C.25 percent
D.35 percent
A.back up the database， stop the wcs， upgrade the wcs， restore the database， start the wcs
B.stop the wcs， back up the database， upgrade the wcs， restore the database， start the wcs
C.back up the database， stop the wcs， upgrade the wcs， start the wcs， restore the database
D.stop the wcs， back up the database， upgrade the wcs， start the wcs， restore the database
When optimizing a standalone point-to-multipoint bridge installation with eight non-root bridges.
Which of the following rts threshold and cwmin settings would be correct for the non-root bridges？（）
A.rts threshold=4000，cwmin=3
B.rts threshold=1，cwmin=4
C.rts threshold=4000，cwmin=5
D.rts threshold=1，cwmin=5
A.debug dhcp enable
B.debug dhcp status enable
C.debug dhcp packet enable
D.enable debug dhcp packet
You are troubleshooting a one-way call problem with a cisco 7920 wireless ip phone on a standalone wlan.
What may cause this problem？（）
A.the minimum data rate is not set to 11 mbps.
B.an address resolution protocol has been disabled
C.publicly secure packet forwarding is enabled
D.the access point is set to the least congested channel.
A.35
B.50
C.100
D.250
A.7
B.60
C.14
D.30
A.mac os x
B.windows 2000 sp4
C.solaris 10
D.windows server 2003
E.debian linux
最新试题
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking，but the status LED and Ethernet LED are both off.What does this indicate？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem？（）
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days？（）