单项选择题

The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.
Before you press and hold the MODEbutton, you should verify that the file name is which of the following?()

A.c1130-k9w7-tar.boot
B.c1130-k9w7-tar.default
C.c1130-k9w7-tar.recover
D.c1130-k9w7-tar.123-7.JA1.tar


您可能感兴趣的试卷

你可能感兴趣的试题

2.单项选择题

You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but, when you answer, the call is dropped.
What may cause this problem?()

A.The minimum data rate is not set to 11 Mbps.
B.An address resolution protocol is enabled.
C.Publicly Secure Packet forwarding is enabled.
D.The access point is set to the least congested channel.

4.单项选择题Which of the following accurately represents the functionality of a lightweight access point configured to operate in sniffer AP mode?()

A.client traffic allowed, data captured on all channels
B.client traffic allowed, data captured on a single channel
C.no client traffic allowed, data captured on a single channel
D.no client traffic allowed, data captured on all channels

5.单项选择题

You are installing a Cisco 4402 Series Wireless LAN Controller.
What type of interface is used on the uplink port?()

A.1000Base-X Mini-GBIC
B.10/100/1000 Mbps RJ45
C.10/100 Mbps RJ45
D.1000Base-SX

7.单项选择题Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance?()

A.Object Definitions
B.Asset Management
C.Location Views
D.Network Connections

8.单项选择题

An REAP was supporting 16 WLANs, but now it only supports one.
What happened to cause the change?()

A.Controller connectivity has been lost.
B.The access point lost its configuration.
C.The access point was rebooted.
D.An access point firmware upgrade is in progress.

最新试题

If it is properly deployed, a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller?()

题型:单项选择题

How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller?()

题型:单项选择题

What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage?()

题型:单项选择题

You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS? ()

题型:多项选择题

You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem?()

题型:单项选择题

A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor,4GB RAM, and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem?()

题型:单项选择题

Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast?()

题型:单项选择题

On a Cisco Aironet 1240AG Series standalone access point, the radio LED is dark blue and blinking,but the status LED and Ethernet LED are both off.What does this indicate?()

题型:单项选择题

You are configuring a wireless LAN controller for QoS.Which 802.11e user priority tag should you apply to voice applications?()

题型:单项选择题

The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton, you should verify that the file name is which of the following?()

题型:单项选择题