A.ballast water
B.boiler water
C.bilge water
D.sewage water
您可能感兴趣的试卷
你可能感兴趣的试题
A.Boiler
B.Incinerator
C.Oily water separator
D.Sewage treatment unit
A.many thousand times larger than
B.the same as
C.many thousand times smaller
D.none of the above
A.lube oil
B.fuel oil
C.turbine oil
D.grease
Which of the following may hardness of the boiler water cause?()
(1) scale formation
(2) tube failure
(3) corrosion
A.(1)and(2)
B.(1)and(3)
C.(2)and(3)
D.(1),(2)and(3)
A.higher than the actual drum water level
B.equal to the actual drum water level
C.increasing due to steam condensation in the glass
D.lower than actual drum water level
A.no combustion
B.deposits in the fuel
C.excessive air in the fuel
D.cold fuel oil
A.swell
B.shrinkage
C.flash off
D.lack of water
A.Water Head Register
B.Water Heater Re-circulating
C.Waste Heat Recovery
D.Waste Handle Reference
A.yellowish flame
B.golden yellow flame
C.milky flame
D.brilliant white flame
As for an oil-fired boiler if at a normal steaming condition and water goes out of sight in gauge glasses the action you should take is: ()
(1) secure oil to fires
(2) increase feed pump pressure
A.(1)
B.(1)and(2)
C.(2)
D.neither(1)nor(2)
最新试题
Who is responsible for ensuring that someone is assigned to close the watertight doors in an emergency?()
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of ().
Which of the following statements is correct concerning heat transfer?()
The major source of chemical contaminants in hydraulic fluid is ().
When the steering gear is in operation, you should ().
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?()
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().
A grease gun is generally used to lubricate a ().
Low compressor head pressure in a refrigeration system can be caused by().